Solid built connector
Posted July 27, 2014
I recently redesigned my downdraft sculpting table and needed a connection that would redirect the dust collection hose at a right angle to the rear instead of straight downward. I did not want the big piece with the rubber gaskets and clamps and this was the perfect solution. I use it with my dust right handle for an easy disconnect but I did need to modify it because the handle wasn't a good fit with this flange.
Fortunately I saved a dust right extension wand that had cracked and was able to cut a piece of it to make a connector that fir between this and the handle
This seemed to be just what...
Posted April 5, 2012
This seemed to be just what I wanted, until it arrived. Right in the middle of the bend, the ID narrowed to 2-3/4" x 3". There is internal bracing on the inside of the bend. Item #34432 would be a better choice, as the ID is constant.