Overview
Perfect miters - no adjustments! Simply cut one piece on the leading face, one on the trailing face, and voila! Since both pieces reference off a perfect 90° angle, the miters will fit perfectly.
- Pre-installed adjustable nylon pins provide a no-slop fit to the miter track.
- Through-slots in the base allow you to securely clamp moldings at table level.
- Can be easily drilled to add extended fences and stops.
- High-impact polycarbonate ensures durability and low-friction sliding.
- Fits a standard 3/8" x 3/4" miter slot.
- Measures 5-1/2" in width and 10-3/8" in length. Clamping faces are 7-1/2" long.
Tech Spec
| Brand | Rockler |
|---|---|
| Manufacturer Part Number | 45 MITER SLED |
| Weight (lbs) | 0.7200 |
Technical Downloads:
Reviews
Customer Reviews
85 Review(s)
View AllBefore I used my miter sled...
Posted February 10, 2012
Before I used my miter sled ..I masked off 3 1/2 " wide "Pads" on the miter rail on the back side ...not the screw side then applied JB Weld to each of those masked areas . After it set up hard I took a flat file and fitted it to my miter slot in my saw ... This works great ...Its very easy to get an exact tight fit and still smooth and easy to slide... and as it wears later I can still bring the screws out ever so slightly to make those adjustments.
I found it easy to use...
Posted May 31, 2011
I found it easy to use and great when I need perfect 45's.It saved my bacon on one recent project.Problems- The plastic set screws used to tighten up the slid in the slot allow you to make not quite 45's although the combined angle is still 90 degrees- The set screws are soft and will wear.- The plastic surface was slippery. Solved this by gluing sandpaper to the surface.
Very simple, safe, easy to use,...
Posted December 31, 2010
Very simple, safe, easy to use, accurate 45's. I had been using a home made sliding table for my 45's. This little jig does it easier and just as accurate.
Videos
Related Products
Swipe to see more
You may also like
Swipe to see more
