Router Table FAQ

This table will fit virtually any router. There are a variety of pre drilled plates to choose from when you order. If your router model is not listed, you can order the blank plate, and drill your own mounting holes to match your router.

What size is the mounting plate?

The mounting plate is 8 inches by 11 inches by 1/4 inch thick aluminum machined to within .010 inch flat.

What size is the hole in the mounting plate?

The hole is 3-1/4 inch in diameter.

What if I want to use a raised panel bit in the table?

Since the hole is not wide enough to accommodate many horizontal raised panel bits, we recommend using vertical raised panel bits. We believe this is actually a safer bit and will give a better cut.

How thick is the table top?

The table top is 1-1/8 inch thick.