Bandsaw Duplicating Pin  Zoom

Bandsaw Duplicating Pin

Item #: 35762
$8.99
Each
Easily duplicate any profile on the bandsaw.

Overview

Easily duplicate any profile on the bandsaw! Just use this handy guide pin with your choice of template to churn out as many identical shapes as you need - perfect for cathedral style doors. The pin can be adjusted to cut just a hair oversized to make final sizing quick and easy; simply leave the template in place and use a flush cutting bit to rout to the line. Attaches easily; just secure it to your guide block/bearing studs with the included hardware assortment.

  • Easily attaches to the following bandsaws: Jet 12" and 14", Delta 14", General 14" & 15" and Powermatic 14". Also fits saws that use the Carter bearing systems.
  • Includes the necessary hardware for installation. On some saws you can use existing hardware that hold in the guide blocks.
  • Slots allow placement to the left or right of the blade as required.
  • Aluminum body measures 1-29/32"W x 23/32"H x 5/32" thick.
  • Pin length can be adjusted with a locking hex-bolt. Ranges in length from approximately 9/16" - 13-16".
  • Related articles

    Tech Spec

    Brand Rockler
    Weight (lbs) 0.5000

    Reviews

    Customer Reviews

    8 Review(s)

    View All

    This is an excellent product.

    Darrel Posted April 14, 2014
    I am a blind woodworker. This pin is simple to use, accurate and safe. I have a Craftsman Band saw. Mine has a Hex shaft. If you have a Craftsman with this type of shaft it will fit. There is no need for instructions. Just remove the bolts that hold your blade guides in place. Find the proper bolts, (long set screws with a place for an allen wrench). Tighten the screws with your guide blocks in the proper position. Put the pin over the two bolts and lock in place with the proper nuts.

    I use the duplicating pin on...

    John W from Berlin, NJ Posted July 5, 2010
    I use the duplicating pin on my 14" Rockwell/Delta band saw every week. Installation was very simple and adjusting easy. I use it every week and it works just fine. It has really helped me speed up the process!I recommend when using it for the first time to put the pin a little farther away from the cut line of the blade then you think which will keep your work piece farther away from the blade until you get use to how it handles. At first take extra care around turns so as not to cut into your template. Thanks again, Rockler

    Installation instructions would be helpful, but...

    Jerry W from Spring, TX Posted November 17, 2009
    Installation instructions would be helpful, but most of us guy's don't read instructions anyway. It only took about 10 minutes to install and adjust. I bought it to make a few adirondack chairs, benches,& swings. Works great. The only reason I didn't rate it excellent is the lack of directions.(Used mine on a 14 inch Jet bandsaw.)

    Write Your Own Review

    Only registered users can write reviews. Please, log in or register

    Videos

    What People are Saying:

    I have been ordering from Rockler for almost 20 years and have found their products to be very inexpensive and of high quality. Shipping is fast even when an item is back ordered. The best prices I have found anywhere."

    - Orval - 08/07/2012

    What People are Saying:

    I have been ordering from Rockler for almost 20 years and have found their products to be very inexpensive and of high quality. Shipping is fast even when an item is back ordered. The best prices I have found anywhere."

    - Orval - 08/07/2012
    Feedback X