Rockler Bead Stile and Rail Router Bit - 1-3/8" Dia x 1" H x 1/2" Shank  Zoom

Rockler Bead Stile and Rail Router Bit - 1-3/8" Dia x 1" H x 1/2" Shank

Item #: 91947
$99.99
Each In Stock
Build sturdy, beautiful frame and panel doors with minimal setup and absolute precision!

Overview

Use this rail and stile router bit set to create beautiful door frames for glass panel, flat panel and raised panel doors. Rockler rail and stile bit sets are manufactured to exacting standards and create perfectly matched cope and stick joints. The one-piece cutting edge allows you to achieve a perfect fit without having to disassemble an arbor and install shims. With ball bearing guide, you can even use a template to build doors with curving rails.

  • K10 and K20 grade carbide for clean cutting action.
  • Final sharpening with 600 - 800 grit diamond wheels.
  • Precision balanced for smooth operation.
  • Baked-on anti-stick coating to reduce pitch and resin buildup.
  • If you are not 100% satisfied with these bits, send them back for a refund.

    Tech Spec

    Brand Rockler
    Weight (lbs) 0.5200
    Bit Type Stile & Rail
    Diameter 1-3/8"
    Cutter Height 1"
    Shank Size 1/2"
    Flutes 2

    Technical Details:

    • 5/8" Bearing.
    • 1/4" x 3/8" Groove.

    What's included:

    (1) Bead Stile and Rail Router Bit Set

    Reviews

    Customer Reviews

    4 Review(s)

    View All

    I made the doors for a...

    Guest from Cypress, CA Posted December 29, 2009
    I made the doors for a china hutch (still in progress) using these bits, and got clean cuts in red oak as long as I used a backer board to control chipout on the exit side of the cut. The joints fit air-tight, and the bearings make positioning the router table fence a breeze.

    I have used the router bit...

    Guest from Murrysville, PA Posted October 29, 2007
    I have used the router bit set in the building of kitchen cabinet doors and found them to be excellent. The matched set is perfect in fit and cutting was smooth. Good quality product...

    I was unsure about using my...

    Michael B from Bartonville, TX Posted February 9, 2010
    I was unsure about using my P-C #691 router at full speed, so I bought the Rockler speed controller. It works just fine, but I was almost at full speed for the cleanest cut anyway!! I also tried taking a 1/2 depth cut first, as I was concerned about the power of my router, but it cut full depth with no problem. I also used the set-up jig, which is a great help, and obtained a really good fit on my first set-up. Excellent stuff altogether.

    Write Your Own Review

    Only registered users can write reviews. Please, log in or register

    Videos

    • Router Bit Setup Jigs: Rail & Stile

    What People are Saying:

    I have been ordering from Rockler for almost 20 years and have found their products to be very inexpensive and of high quality. Shipping is fast even when an item is back ordered. The best prices I have found anywhere."

    - Orval - 08/07/2012

    What People are Saying:

    I have been ordering from Rockler for almost 20 years and have found their products to be very inexpensive and of high quality. Shipping is fast even when an item is back ordered. The best prices I have found anywhere."

    - Orval - 08/07/2012
    Feedback X