|Manufacturer Part Number||H03-095-0076|
2 Review(s)View All
Not Bad Once You Figure Out the TricksPosted October 26, 2014
- Snap/slide the brackets onto the slide (I had no problems requiring bending the brackets)
- Hold the slide in place in the drawer, to determine the length (face frame-to-cabinet-back dimension)
- Predrill and screw through the hole at the end of the drawer slide (there's only one hole). I just used a Vix bit to predrill in the center of the hole, and zapped in a sheet metal screw. You can use a machine screw and bolt instead
- Install slider in cabinet. One annoyance is that you have to hold up the slider in an arbitrary floating point in three dimensional space (right angle to the cabinet front, level). I used a 3/4" pipe with a pipe flange and the tail of a pipe clamp to do this.
Almost worthlessPosted June 7, 2014
A better bracket is in order.