Deluxe Drawer Pull JIG IT®

Very nice jig. However, some instructions on its uses would have been nice. My jig had a couple of extra pieces that I still can't figure out what they are for or how they are used.

Nice jig, and one of the nicest ones I could find on the web. I had to do the whole house, which was about 50 knobs and 40 pulls. For knobs, the punch is a nice feature, much better than using a punch and hammer. I used masking tape and measured the horizontal center and vertical distance, then used the plate and punch to mark the hole. For the pulls, the jig really shines. The centerline really makes this job easy since you can tighten down the jig after perfectly level (use a small level), them move to vertical centerline to your masking tape center mark. Punch the correct spacing, and your done with the tool. This tool is perfect, although each user should remember that the cabinet makers are far from perfect. You'll find that adjacent cabinets are not level with each other, so you'll need to adjust the level each time you move from cabinet/drawer to the next. It sounds tedious, but this tool has made this job very easy. A bit of advice, when you have two pulls close to each other.. just draw you horizontal line level with the adjacent knob/pull. If you don't, knobs close to each other will look uneven (due to door height differences). Good luck, it's worth the money.

The jig is OK but not as nice as I would like. The stop used for positioning barely catches the edge of the chamfered cabinet door or drawer. You have to be very careful when using it or the marking will be off. When using it on cabinet doors it needs to be set up for both right and left opening doors. I can't figure out how it can be used on both type with one setting. There may be a way to do it, but it comes with no instructions. It is fairly simple to figure it out, but some instructions would be nice just as a way of confirming the setting is correct. It comes with a tape measure that can be attached to T-track. There are no pictures or instructions on where to attach it.