Overview
Hold your turning blanks firmly to your faceplate without screw holes. Tape holds best to smooth, even and finished wood surfaces. With your blank held firmly, you can focus on turning your most beautiful pieces yet! Tape roll is 1" wide x 36 yards long.
Tech Spec
| Manufacturer Part Number | 505w |
|---|---|
| Weight (lbs) | 0.7600 |
| Type | Tape |
Reviews
Horrible tape. Arrived with the plastic...
Posted March 10, 2013
Horrible tape. Arrived with the plastic bag melted into the side of the roll. Worse than that, you cannot peel the backing off this tape! The backing is not paper. it's a very thin layer of cellophane-like plastic. Try putting a piece of duct tape on a sandwich bag and try to peel the bag off the tape. Nightmare stuff. /p>
I used this for turning some...
Posted December 5, 2012
I used this for turning some small jewelry box tops and it worked great. This tape was much stronger than some of the thin hobby stuff I tried (which wouldn’t hold the pieces at high speed) and not unduly thick or spongy like some others. I’d have to agree that the backing is pretty hard to get off but I found that by slicing it with a utility knife, and then prying up an edge, I was able to get it off without too much trouble. Very little residue was left on the turning or the faceplate – but then I didn’t leave it on there too long either.
The backing is impossible to peel...
Posted October 3, 2012
The backing is impossible to peel and the tape is just about full. The remainder was torn off to use but useless as the backing is bonded too good to the tape so I will use the tape as one sided tape instead. I will not buy this product again
The tape is flimsier than other...
Posted June 30, 2011
The tape is flimsier than other brands, so it will bunch up more easily once the backing is removed. This causes waste. Moreover there is often glue residue left on the wood, unlike other brands I have used. I bought the tape half price on sale, so "you get what you pay for." Had I bought it full price, I would have really been pissed off.
I resaw old lumber and place...
Posted May 2, 2011
I resaw old lumber and place several pieces in tandem to plane to thickness. This tape held so well I thought I was going to have to saw the pieces from the slats I used to plane with. I have not used it for turning a project yet, but I'm sure it will work fine.
Videos
You may also like
Swipe to see more
