If you can iron you can apply Edgemate! Just position edge banding and heat with either our hand held iron or edge banding machine. This item backing creates a permanent bond. Then simply cut and trim edging to make plywood look like solid stock. Accepts stains and finishes.
1) Submitted by
Frank Larson, from Medford, WI
on 10/11/2009
Customer Rating:
First time I used it, perfect results. I used my instant read kitchen meat thermometer to check the temperature of my old clothes iron. Application temperature was approximately 310 to 320 degrees. could even lift the edging and re-apply when one piece slipped to the side. Used a 1 1/2" thick wood disk as a roller for the edge and to press over the corner.
2) Submitted by
Dennis Griffiths, from Monterey, TN
on 10/11/2009
Customer Rating:
I have never used the iron-on product before, but it saved a lot of time and cleanup. The material is the perfect size, line up one edge and trim off the other edge, sand and it looks like part of the wood. The product was very easy to use, if a mistake is made, just reheat and shift. The only "con" that I see is I would have liked to see more grain in the edging.
3) Submitted by
Jim Wright, from Wilmerding, PA
on 8/18/2009
Customer Rating:
I have not used this product yet, but have used it in the past. It is an excellent way to use "cabinet grade" birch to build furniture and make it look like solid boards.
4) Submitted by
Greg Larson, from Iron Mountain , MICHIGAN
on 5/19/2009
Customer Rating:
The adhesive has changed since I last purchased the product and it does work ok. I think the old adhesive was better, but the product is still good. I like the width of the strip - it is much better than the Home Depot strip that is exactly 3/4" wide. The extra width on the Edgemate helps make a good quality job. It can be overhung, trimmed with a Stanley knife and then sanded to make an edge that is invisible from a solid board.
5) Submitted by
Don, from Milford, MA
on 4/17/2009
Customer Rating:
Great Product - and great service. Easy to use and makes a 3/4 inch maple plywood piece look like a maple board at half the price.
6) Submitted by
Kevin Stepuin, from Rochester, WA
on 12/10/2008
Customer Rating:
Great product - matched my Maple plywood perfectly - difficult find maple in other places - must not be as popular as other hardwoods. Easy to use - Great results
7) Submitted by
Mark, from Nebo, NC
on 12/9/2008
Customer Rating:
Very good product. Easy to use, compared to edge banding that I had to apply glue this is the one we'll use from now on.
" Wow you guys never cease to amaze me! I ordered some clamps & things 1 morning and got the stuff the next day. Not only good stuff but fast too! Beats running around looking for them in stores waisting gas and time! Joe Pynenberg Little Chute WI " -
Joe Pynenberg
- 01/30/2009 See more...
CART
