1) Submitted by
Barrie, from Hunter, MA
on 12/2/2007
Customer Rating:
I think this is the worst engineered piece of equipment I have ever purchased. I had to modify both it and the cabinet I installed it in to make it fit despite the fact that the cabinet dimensions were all within those stipulated in the catalog (you should include a statement to the effect that any existing cross pieces on the front of the cabinet under the drawer will impact the ability to install this without major modifications.
And after getting it installed and putting the kitchen mixer on it the whole assembly swayes from side to side when raining or lowering the unit, even after I stiffened it up by substituted machine screws and nuts for the wood screws you included to fasten the shelf to the brackets.
2) Submitted by
James Kallas, from Ham Lake, MN
on 1/2/2009
Customer Rating:
I am very disappointed in this product, It looked so nice in the photo and the idea is great,but, the product is weak. I was installing it for an elderly person who did not want to have their mixmaster on the counter anylonger. I found this swing shelf in the book and I thought it would be great for this application, but, after I installed it and tried it for the first time, the locking tabs bent and the shelf would not lock in the up position without pushing the locks back into place, also when lowereing the shelf, the right side would drop much faster thant he left side. I spent about 2 hours trying to find what caused this to happen. I measured and re-measured to make sure I followed the directions (which are poor at best)to the letter. I supported the brackets, took the supports out, tried to readjust the location of one side thinking that they were not equal, but, my tape measure and level didn't lie to me. So after trying several of this adjustments, I said it just isn't going to work properly, and I removed it form the cabinet opening and boxed it back up.
3) Submitted by
Jim, from Sheboygan, WI
on 9/26/2008
Customer Rating:
I'm so disappointed with this lift. The instructions don't show that the springs intrude into the shelf area so the custom cabinet I made for this ended up being about 2" too narrow for the equipment. The metal locking tabs are made from cold-rolled rather than spring steel so the 1st time we released the mechanism, they bent and wouldn't lock anymore.
"I have just receieved a Router Plate for my Router Table to be used w/ a Porter Cable 890 Router. Everything fit up perfectly. I would like to thank your staff for a fast responce and quality material.
" -
Don Krause
- 10/06/2008 See more...
CART
(1.0)
