Top quality bits that meet the high demands of Rockler Woodworking and Hardware.
ROUTER
BIT DIMENSIONS
Two
flutes
Item
No.
A
B
C
D
R
91133
1"
1/2"
1/4"
1-1/4"
1/4"
91144
1-1/4"
1/2"
1/2"
1-1/2"
1/4"
A
fantastic value on high quality router bits. These bits are
competitively priced while offering high performance and long
life.
Quality performance features include:
K10
and K20 grade carbide for clean cutting action.
Final
sharpening with 600 - 800 grit diamond wheels.
Precision
balanced for smooth operation.
Baked-on
anti-stick coating to reduce pitch and resin buildup.
If
you are not 100% satisfied with these bits, send them back for
a refund.
These
larger bits are designed to be used in a router
table.
Router Bit Set-Up Jigs - Set your
router bit to the precise height every time! Simply bring the router bit up through
the table and align the jig with the cutting edge of the bit.
Router
Safety Tips:
It's easy to prevent mishaps if you take a few simple precautions.
1) Rockler recommends using 1/2'' shank router bits whenever possible.
1/2'' shanks provide better stability with less vibration to produce a smoother
cut and longer cutter life. 2) Make multiple light passes rather than one heavy cut. 3) Install your router bit so that 90% of the shank is inside the
collet. Here's a rule of thumb: fully insert the bit, then pull it back
1/16 to 1/8 of an inch. 4) Use a router table whenever possible. 5) When using large diameter bits, reduce the RPM of your router.
Then test your set-up on scrap lumber. 6) Always follow your router manufacturer's recommendations.
Customer Reviews and Photos for: 1'' Dish Carving Router Bit
1) Submitted by
Bill Matthews, from Eustis, FLORIDA
on 12/29/2008
Customer Rating:
I bought this bit to aid me when I make wooden spoons. I do this free hand and I'm still working on getting better at it.
2) Submitted by
Gleason Grimes, from Milford, NE
on 8/20/2008
Customer Rating:
I used it on a router table to rout out trays that fit in a men's jewelry box. It did an excellent job.
3) Submitted by
Gene, from Hamilton, MS
on 5/28/2006
Used the 1/4" shank dishing bit in a router table to make the hand grips on the end of the large board and to cut away the bottom side of the sink insert to obtain a good fit. The bit worked quite well, with little to no burning, clean cutting. Very satisfied with it.
CART
Two
flutes
If
you are not 100% satisfied with these bits, send them back for
a refund. 
These
larger bits are designed to be used in a 
