These ready to install, pre drilled wooden blocks take the guesswork out of leveling.
These ready to install, pre drilled wooden blocks take the guesswork out of leveling. inserted, nylon covered 3 1/8'' glide is adjustable to a height of 2'' either through a hole in the cabinet floor or from below with an open ended wrench. Overall height is 3''. Load rated for 150 pounds each.
1) Submitted by
W. D. Atwood, from Hayward, CA
on 5/15/2009
Customer Rating:
For a bookcase that is not going to be carrying a heavy load, they are fine. I myself, don't care for the pine blocks.
2) Submitted by
Tom Blanck, from Lexington, KY
on 2/22/2009
Customer Rating:
These wooden leveler blocks come with 2 mounting screws which is nice. I used these on 8' tall by 3' wide by 18" deep bookcases to take out any unevenness that might be in the floor. I glued and screwed these blocks inside each corner of the bookcase. I drilled a hole through each corner of bottom shelve of the bookcase so I would have access to the adjusting screw in each level block. After installing these I did have to adjust them to make the bookcase level and not wobble.
3) Submitted by
Robert M. Thorndike, from Bellingham, WA
on 12/15/2007
Customer Rating:
I am constructing a set of eight 2'x8' bookcases to be connected into an 8'x16' finished product. Getting the bottom shelves of the 8 individual units exactly even would have been much more difficult without these levelers. Having the blocks made of wood makes it a snap to glue and screw them in place, and being able to adjust them from the top or bottom is a real plus.
4) Submitted by
Bob Phillips, from Sandpoint, ID
on 8/6/2009
Customer Rating:
The provided screws did not start and drive very well, although they seem to be very good hardware. I redrilled one of the mounting holes through the other face of the block so that I can pull them solidly into the corner of the cabinet.
5) Submitted by
Alex
on 2/14/2008
Customer Rating:
The wood blocks are soft pine so don't have as much structural strength as they could. Having this preassembled is nice.
"I have just receieved a Router Plate for my Router Table to be used w/ a Porter Cable 890 Router. Everything fit up perfectly. I would like to thank your staff for a fast responce and quality material.
" -
Don Krause
- 10/06/2008 See more...