Sandmaster
- Frequently Asked Questions (FAQ's)
|
Health
& Safety
|
Maintenance
|
 Use eye protection and dust mask when using the Sandmaster. |
 Always
ensure there is a slight gap between bush and main body. Place a spot
of oil on bearing before each use. |
|
Sanding
|
|
 |
Allow the sanding disc to run freely on the workpiece with the lathe running at a maximum of 1500 RPM |
| Keep sanding disc moving over workpiece with minimum pressure to reduce excessive heat build up. |
 |
 |
Do not allow the abrasive disc to become smooth as this will over-heat the workpiece and potential damage may occur. |
| When removing abrasive discs, place thumb over edge of pad to avoid damage to the sponge pad. |
 |
|
Finishing
|
|
 |
By fitting a pigtail mandrel and cotton mop - these are optional extras- the Sandmaster becomes a handy buffing tool. Simply add wax or oil for a fine finish. |
|
Optional
Extras
|
|
| Your Sandmaster comes complete with a 2" sanding pad and 2" abrasives in 60,120, 180, 240 and 400 grit. | |
|
Need Help? |
(1)