Measuring your doors and drawers for cabinet refacing
Door and drawer fronts will be custom-made to the sizes you specify so accurate measurements are critical. You will need to measure all door openings to the nearest 1/8’’ and then add in adjustments based on the type of hinge and overlay required. Do not order rough opening sizes.

Door Width

Door Height

Drawer Width

Drawer Height

Pick your hardware first: This will determine what size overlay is needed.
Measuring opening size: (Do not order by these opening size dimensions.)
Measure all door openings to the nearest 1/16".
Always write width first.
Figuring order sizes:
For 1/2" overlay add 1" to the width and 1" to the height of each opening size. If your application requires a different overlay, adjust the measurements accordingly. For inset applications, subtract no less than 1/4" on both width and height of cabinet opening measurements. Doors and drawer fronts will be custom-made to the sizes you specify, so measure carefully.
1. Order two doors to cover any opening more than 22" wide. Doors over 26" in
  width and/or 46" in height will have double panels.
2. We guarantee no warping or cracking on doors sized up to 23" wide and/or 46"
  high; drawer fronts up to 30" wide and/or 12" high.
3. Doors exceeding the maximum sizes listed may be possible but require a special quote.
Click here to go through our order process and place an order.
Pricing example:
An 11-3/4" W x 20-3/4" H raised panel door, style #35778 in Oak, would cost $33.19. A 16" W x 5" H drawer front, style #7 in Oak, would cost $9.67.

Are you ready to order?

Double-check all measurements (did you add an inch for 1/2'' overlay?).
If you are not painting your existing cabinets, have figured your veneer needs?
Make sure you’ve ordered everything you need, including hinges, knobs and pulls and trim moulding.
It will take approximately three to four weeks for your custom order to arrive.
Click here to proceed to our Online Ordering Program