Brusso Jewelry Box Lid Support

Small version of brass mortised support. Cut a mortise 1/4'' wide x 2-7/8'' long x 1/2'' deep to install. Solid brass.

Cut a mortise 1/4'' wide x 2-7/8'' long x 1/2'' deep to install. Solid brass.

Jewelry Box Lid Support

Jewelry Box Lid Support Datasheet

Customer Reviews and Photos for:
Brusso Jewelry Box Lid Support

Average Rating:

(4.0)
(5 customer reviews)
Add your review...

1) Submitted by Wayne Brieske, from Kenosha, WI on 7/6/2010

Customer Rating:

Much easier to install than Quadrant Hinges and quality is excellent. I use these for Ashes Urn-boxes, Wedding gift card boxes and all other decorative boxes.

2) Submitted by David Wood, from Perryville, MD on 2/12/2009

Customer Rating:

This hardware is of good quality, but I found it lacking in design. The lid "support" will keep the lid from going back to far, but there is nothing in the design to secure the lid open. I used the support on a lid that was probably a bit large for the design of the support and I had to modify the support to allow the lid to open enough to stay put. On a smaller box without the extra weight in the lid, the support would probably work well, but it requires some care to install properly in a box with thin sides.

Painter's box rosewood brush rack in lid

3) Submitted by Vincent Martines, from Merrick, NY on 5/10/2008

Customer Rating:

Works great and easy to install.

4) Submitted by Harry Kittleman, from Cheyenne, WY on 4/29/2008

Customer Rating:

Looks great and works well but care must be taken when mortising in thin brittle stock to avoid breakout. Have had no problem with woods like walnut but figured cherry is tough to work with.

5) Submitted by Eric Olson, from Washington, DC on 11/27/2007

Customer Rating:

Worked well for a small box. Directions were clear and simple for installation. Rabitting the insertion grove requires significant set up time and is critical for proper performance.

Customer Reviews and Photos for: Brusso Jewelry Box Lid Support

Customer Reviews and Photos for:
Brusso Jewelry Box Lid Support