Easy drill depth & fence distance setup
Posted December 27, 2013
I bought the hinge cup drill jig to setup for drilling 1/2" overlay face frame doors. On first setup on my drill press, when lowering the 35MM bit into the jig the fit was extremely snug. I clamped the jig to my fence and turned on the drill press to ream out the jig. After that the jig provide quick & easy setup of drill depth and distance from the fence. I am rating this jig at 5 Stars despite the original snug fit because it provides such fast & easy setup for drilling hinge cups. I would recommend this jig to anyone who wants easy setup for drilling hinge cups.
Does exactly what it is suppose...
Posted April 11, 2013
Does exactly what it is suppose to do, by making setup's for Euro door hinges simple. Picked this Jig-It up to help me build a custom Computer Stand for my wife's work place that would have flush mounted doors. With the right Jig-It for flush doors, the picture, and a test drill later. I was ready to go. Works great and is dead on. By far one of the simplest to use jigs I have bought from Rockler yet. Couldn't be simpler, narrow side to the fence, set your depth of cut and fence distance by placing the 35mm bit into the cup. An adjustment to the depth of cut may be required if your doors are not the same thickness as the jigs. My doors were not as thick as the template, so I marked the bits depth in the Jig-It, and drilled a test depth hole in some scrap the same thickness as my doors. I tested the depth of cut, with one of the actual hinge cups I was going to use. Once set up, you now only have to worry about setting your end stops correctly, while making sure you don't drill the wrong side of the door. I was able to do all 4 doors in one setting with a perfect fit for each one. I would recommend this Jig-It. It works.
Worked well. I have a small...
Posted July 6, 2011
Worked well. I have a small drill and extension table with fence. It was instrumental in the quick setup process of my drill press. The only thing I would like to change would be to make the distance from center mark to either edge the distance recommended by most hinge makers. This would allow for quick placement of the stop on the drill press fence. I would buy again and would recommend it to a friend.