Back to Woodworking Basics
posted on January 16, 2010 by Ralph Bagnall

In a world of whizz-bang gadgets and high tech tools, a recent thread on a woodworking forum reminded me that sometimes we need to stop, rewind and get back to the basics. The poster was lamenting that he had no idea how to drive a screw. This may seem silly, but it really is an honest question.

As a cabinet maker I use high tech, square drive, self drilling screws with nibs under the head that help them sink without dimpling the plywood. Just drive it and move on to the next.

But as a builder of reproduction furniture, I often need to assemble hardwood pieces using (gasp!) old fashioned, flat head wood screws, like this one holding the top of a small, two drawer table.

This is not a drive and go situation. Just forcing a common wood screw in would tend to split the wood, and often the two parts will not draw together properly. A pilot hole is needed.

Actually, two pilot holes are needed. Well, ok. What we really need is two pilot holes of different diameters and a countersink so that the screw head does not protrude above the part.

When joining two parts like the frame and top of the table pictured, the frame needs a hole big enough so that the screw can pass through, but not so big that the head will. The top needs a hole wide enough to accommodate the body of the screw without splitting, but not as wide as the threads or they will not hold. The two different holes allow the threads to twist into one part while not binding in the other.

Rockler Screw-LubeRockler Taper BitLastly, a countersink in the through hole sets the screw head slightly below the surface. Waxing or otherwise lubing the screw can help keep the head from twisting off, especially with brass screws.

Fortunately, there are good options for drilling all of these at once. Tapered drills create a larger hole above, and narrower at the tip.

Typically, this is a compromise, but works pretty well. Add a countersink to the tapered bit, and all three operations can be covered in one. The countersink is even adjustable along the tapered bit so you can set the proper drill depth.

Hmmm, we seem to have come full circle, back to a whizz-bang tool that helps us work faster.

posted on January 16, 2010 by Ralph Bagnall
previous post next post

4 thoughts on “Back to Woodworking Basics”

  • westwoodhacker

    I've found it beneficial to put a very light countersink on the bottom of the shank hole so when the threads bite into the wood and dimple up they have a place to go. It makes for a better fit between the 2 pieces of wood.

  • Ralph Bagnall

    Excellent idea when drilling pilot holes seperately! Thanks for sharing it. When using a drill/countersink combo bit, keeping the parts clamped tightly together as they are drilled makes for a clean pilot hole in both parts.

  • Fred

    Using a bar of soap or wax on screw threads works well lub them
    when putting them in wood.

  • Ralph Bagnall

    Good advice Fred! Also, solid brass screws are quite soft, so drive a steel screw in first, remove it, then drive the brass screw in. This will save twisting the head off.

Comments

What People are Saying:

I have been ordering from Rockler for almost 20 years and have found their products to be very inexpensive and of high quality. Shipping is fast even when an item is back ordered. The best prices I have found anywhere."

- Orval - 08/07/2012

What People are Saying:

I have been ordering from Rockler for almost 20 years and have found their products to be very inexpensive and of high quality. Shipping is fast even when an item is back ordered. The best prices I have found anywhere."

- Orval - 08/07/2012
Feedback X