Router Table FAQ
posted on August 15, 2013 by Rockler

Will my router fit the table?

This table will fit virtually any router. There are a variety of pre drilled plates to choose from when you order. If your router model is not listed, you can order the blank plate, and drill your own mounting holes to match your router.

What size is the mounting plate?

The mounting plate is 8 inches by 11 inches by 1/4 inch thick aluminum machined to within .010 inch flat.

What size is the hole in the mounting plate?

The hole is 3-1/4 inch in diameter.

What if I want to use a raised panel bit in the table?

Since the hole is not wide enough to accommodate many horizontal raised panel bits, we recommend using vertical raised panel bits. We believe this is actually a safer bit and will give a better cut.

How thick is the table top?

The table top is 1-1/8 inch thick.

posted on August 15, 2013 by Rockler
previous post next post
Comments

2 thoughts on “Router Table FAQ”

  • Charlie Miller

    I have the Rockler router table and insert plate, but am missing the pin for pattern routing. Do you see it separately?

  • Harry Feit

    I want to buy a router table with list, but I have a Bosch MRC23EVSK 2.3HP VS router...

Leave a comment

What People are Saying:

I have been using Rockler for years, your products are always the best that can be purchased and your prices are very reasonable. Ann you have always done your best to make me feel as though I was your very best customer. Thank you for great service."

- Daniel F.

What People are Saying:

I have been using Rockler for years, your products are always the best that can be purchased and your prices are very reasonable. Ann you have always done your best to make me feel as though I was your very best customer. Thank you for great service."

- Daniel F.
Feedback X