Sanding Small Projects and Tight Spaces on Your Lathe
posted on February 1, 2008 by Woodworker's Journal

When I’m finishing small projects on the lathe, especially captive rings, it’s tough to sand into small crevices with the right amount of pressure if you can’t get your fingers in close. Here’s an easy sanding “tool” that works well for me: I take a piece of sandpaper and fold it over the end of my parting tool, then secure it with blue painter’s tape. It helps me sneak into even the tightest spots.

posted on February 1, 2008 by Woodworker's Journal
previous post next post
Leave a comment

What People are Saying:

I have been using Rockler for years, your products are always the best that can be purchased and your prices are very reasonable. Ann you have always done your best to make me feel as though I was your very best customer. Thank you for great service."

- Daniel F.

What People are Saying:

I have been using Rockler for years, your products are always the best that can be purchased and your prices are very reasonable. Ann you have always done your best to make me feel as though I was your very best customer. Thank you for great service."

- Daniel F.
Feedback X