|
Cutting
Procedures
1. Cut all pieces to sizes as indicated on Coffee Mill Dimensions
below.
2. Rabbet parts
C and D as shown to accept side B.
3. Router outside
edges of base piece A (and top piece E if building for #41846
Cast Iron Wheel Mechanism) with Roman Ogee bit (#91639) or decorative
bit of your choice.
4. Drawer side piece W and drawer back piece X require 1/8" groove 3/16" deep and 1/8" up from bottom.
Assembly
1. To make the base, glue pieces B, C and D
together. After glue has dried position box on piece A and attach.
If nails are used, always pre-drill holes to prevent splitting.
2. Next glue
and or nail drawer pieces together. The front of the drawer has rabbeted
ends to fit over B pieces. Center knob on drawer front and screw
in place.
3. Assemble
coffee mill mechanism. Cover fits over bowl mechanism with stem of bowl
facing up. Next, drop crank handle in place and tighten with cast iron
nut and wing nut.
If using the wheel
type grinder, the mechanism must be attached to the top (E) before
the top is attached to the box.
To attach the mechanism
to the top, the shaft and lower grinder unit must be apart from the bowl.
Center bowl on top (E) to determine location of holes for the two
machine threaded bolts. Note: Position top grinder so wheel is parallel
to sides. Mark and drill 5/32" holes. Attach bowl.
The stem and lower
grinder unit are then brought up from the bottom side of E. The flange
on the lower grinder unit should be down. Attach lower unit to E
with two small wood screws. (There will be a small gap between the flange
and the underside of the top. This will be inside the box, will not be
seen and will not interfere with the operation of the grinder.)
Complete assembly of mechanism before gluing Top (E) to the sides.
4. Sand and
finish.
5. Place mechanism
on base and screw in place.
|
CART
