Works perfectly with 3/4' thick face frames and casework and stock up to 3' wide  Zoom

Exclusive

Rockler Pock-it Hole Clamp® with Quick Release

Item #: 41425
$21.99
Each Oversold until 02/10/2015
Reserve Yours Today
Clamp and align pocket hole joints faster, with better accuracy, and control!

Overview

The Pock-it Hole Clamp® with a new Quick Release features a unique design that inserts a built-in adjustable pin into a 3/8" x 15° pocket hole, giving you perfect alignment every time. Now setups are even quicker and easier with the new quick-release slide button to snug up your fit, then use the ratcheting handle for final tightening. The clamp has all the clearance you need to clamp and fasten double joints in one easy step. Simply clamp the joint using one hole, then insert a screw in the other hole and tighten. Works perfectly with 3/8" pocket holes on 3/4" thick face frames and casework, and stock up to 3" wide.

  • Unique design allows easy clamping and surface alignment of pocket hole joints
  • The adjustable pin fits in a 3/8" x 15° pocket hole while the clamp tightens the joint
  • Works in 3/8" pocket holes on 3/4" thick face frames and casework
  • Clearance in the clamp body enables clamping and fastening of double joints in one easy step
  • Ratcheting handle allows for clamping face frames flat on the workbench
  • Tighten or release the handle quickly and easily using the new quick-release slide button
  • 3" wide stock capacity

Tech Spec

Brand Rockler
Weight (lbs) 0.8200

What's included:

(1) Pock-it Hole Clamp® with Quick Release

Reviews

Customer Reviews

11 Review(s)

View All

great idea

Brian Posted January 13, 2015
Before I wasn't sure if it was going to work as good as it said, so I just bought one. Needless to say I recently ordered 3 more. It's great for pulling the material tight together and not just relying on the screw to pull them together. I still use a face clamp to hold the material flat but otherwise this will be getting a lot of use from now on.

Great Clamp

Buddy Posted September 10, 2014
I received one of these as a gift. I have just used it to construct a face frame. It is fantastic and easy to use. I found none of the problems mentioned is a couple of reviews here. The 3" frames were held very flat, the quick released worked fine after simply releasing a little pressure off with the screw handle. One suggestion to the design might be to have a screw handle that would allow the clamp to work on a flat floor. Either a ratchet, a removable handle to use our own ratchet, or a flip handle to allow 180 degree turns alternately via a flip of handle side to side. But all in all, I say as is it is easier than the Kreg clamp. Great Work Rockler, I'm ordering a second clamp.

Works great. It makes the job...

David L from Lakeland, FL Posted September 25, 2013
Works great. It makes the job so easy!!!!!!

Write Your Own Review

Only registered users can write reviews. Please, log in or register

Videos

  • Rockler Pock-It Hole Clamp
  • Rockler Pock-It Hole Clamp at AWFS 2011

What People are Saying:

I have been using Rockler for years, your products are always the best that can be purchased and your prices are very reasonable. Ann you have always done your best to make me feel as though I was your very best customer. Thank you for great service."

- Daniel F.

What People are Saying:

I have been using Rockler for years, your products are always the best that can be purchased and your prices are very reasonable. Ann you have always done your best to make me feel as though I was your very best customer. Thank you for great service."

- Daniel F.
Feedback X