Customer Reviews and Photos for:
J-Square Center Finder
|
Average Rating:
4.0
(14 customer reviews)
$3.29
Add your review...
|
|
|
1) Submitted by
Larry, from Sugar Grove, PA
on 12/7/2011
Customer Rating: 
So easy a child could do it. I was using a square and a tri-square which works fine but takes a little extra time to set up. This J-Square is always ready to go. I just grab it off the wall and zip zip it is done.
|
|
2) Submitted by
Bill, from Fairfax, VA
on 11/22/2010
Customer Rating:
Simple, easy to use, lightweight, unobtrusive on my tool wall.
|
|
3) Submitted by
Jeff S. Puskos, from Highland Village, TX
on 9/17/2009
Customer Rating:
very easy to use and accurate. highly recommended.
|
|
4) Submitted by
Paul Murray, from Casselberry, FL
on 9/16/2009
Customer Rating:
This is a great tool. It makes finding the center of round stock easy, quick and fool proof and for the price you can't beat it.
|
|
5) Submitted by
Liz, from Spring Grove, MN
on 8/31/2009
Customer Rating:
Makes the job alot easier.
|
|
6) Submitted by
Bob Bender, from Celina, TX
on 8/30/2009
Customer Rating:
Samll, accurate and inexpensive!
|
|
7) Submitted by
John, from Bandera, TX
on 5/30/2008
Customer Rating:
Unique design takes up less space in storage. Very well made for such a low price.
|
|
8) Submitted by
TC Marshall from VA
on 5/3/2008
Customer Rating:
Very easy to use and a reasonable price.
|
|
9) Submitted by
Jim Jennings, from Santa Teresa, NM
on 4/15/2009
Customer Rating: 
The tool came warped with a slight twist. It should have been shipped on cardboard. I think it bent in the mail. I warmed it up with a heat lamp and clamped it down. Works as advertised. Good price!
|
|
10) Submitted by
Jim, from South Point, OH
on 8/31/2009
Customer Rating: 
Mine was warped too. Not quite sure how to use it. A simple 1 page instruction sheet would have been nice. Just feels kinda cheap, but that's what you get for 6 bucks.
|
|
11) Submitted by
Chris Coombs, from Deerfield, NH
on 9/18/2009
Customer Rating:
This tool is great for dowels and rods over 2" in diameter. I tried to make it work on a 1" dowel and the dowel slipped through the nubs that line up the tool to find center. It was totally useless in this application. But for centering larger work, it would be a breeze.
|
|
12) Submitted by
P Campbell, from San Diego, CA
on 12/17/2012
Customer Rating:
This item is fine - for large stock. But anything under an inch becomes problematic and anything under half an inch is impossible. For turners who do finer work, this is not much of an option. If you need a center finder that handles a large variety of stock sizes, you might want to look at the other Rockler center finding tool option.
|
|
13) Submitted by
Bj, from Tampa, FL
on 10/6/2009
Customer Rating:
It works great with large diameter rounds stick. But the round is less than 1 inch in diameter, which I most often use, this one doesn't work.
|
|
14) Submitted by
Bob, from Miami, FL
on 4/4/2008
Customer Rating:
Nice product at an excellent price.
|
Hand Tools and Shop Accessories 
(0 Items)