Our exclusive 1/4'' thick aluminum plate is the only plate that is both large and strong enough to offer maximum support for larger routers (2 HP and up). It allows you to easily install heavy-duty routers into all types of router tables!
Plate measures 9'' x 13'' - 30 square inches larger than our standard plate. The 3-5/8'' opening is large enough for horizontal raised panel bits. Includes two Delrin inserts; one 1-1/2'' Delrin insert and a blank insert. Pre-drilled for Rockler Fulcrum Pin.
Choose the plate that is already pre-drilled for your router. A blank plate is also available to allow you to drill to the specifications of makes and models not listed below.
Note: #62272 Plate fits Hitachi M12 routers only. Does not fit Hitachi M12VC.
1) Submitted by
Rob, from Watkinsville, GA
on 8/2/2009
Customer Rating:
The first one I received had about 1/16 of a dip across the middle, Rockler was very quick to correct the problem. The replacement is dead flat. I needed a plate that was at least 12" wide to replace my old polycarbonate base plate. The other Rockler plates aren't wide enough, so I bought a blank "large" plate and mounted my PC 890 router in it. the larger opening required some modification of the inserts, but overall the router fits fine even though it's not a "large" router.
2) Submitted by
Clint, from Phoenix, AZ
on 7/20/2009
Customer Rating:
Good router base plate, even though this is listed for a PC 7518 I used it on my PC 7519 w/ no problem.
3) Submitted by
Fred Fletcher, from Flowery Branch, GA
on 5/18/2009
Customer Rating:
The product is great and meets my needs very well. I do have an issue however with the process. I bought a new Router plate with a lift. When I tried to buy this insert at the store I was told it was only available on line. If you are going to sell the lift in the store then sell the insert in the store or wave the shipping cost.
Fred
4) Submitted by
Kevin, from Columbus, OH
on 11/25/2008
Customer Rating:
Great plate that I'm using a Bosch 3 1/4 HP router. Fits like a glove in the table.
5) Submitted by
Jon, from Whittier, CA
on 8/11/2008
Customer Rating:
High quality plate. Arrived in excellent condition. Put in my hand fabricated router table. Works great!
6) Submitted by
Aage Olsen, from Pinetop, AZ
on 11/11/2007
Customer Rating:
This is my second router plate. It is by far the strongest and best router mounting plate I have found.
I built a router table with two routers and this plate is the ones I used for both Freud routers and the plate fits the routers perfectly
7) Submitted by
Milan Kruse, from Brookings, SD
on 6/12/2008
Customer Rating:
Very nice plate. I love the predrilled mounting holes for the router. Could use a hole for starter peg.
Editor's note: These plates have a pre-drilled and pre-threaded 1/4"-20 hole for use of an optional fulcrum pin (starter pin).
"Rockler is the leading name in Woodworking around here...always has what you need and more...Great service to boot. Thanks for being there." -
Dick Farino
- 01/04/2009 See more...
CART
Plate measures 9'' x 13'' - 30 square inches larger than our standard plate. The 3-5/8'' opening is large enough for horizontal raised panel bits. Includes two Delrin inserts; one 1-1/2'' Delrin insert and a blank insert. Pre-drilled for Rockler Fulcrum Pin.
