Related Products
|
- Overview
- More Info
- Reviews
Choose the right screws for the wood your using. These screws, with their square drive washer heads, ensures that the screw will seat in the bottom of the pocket hole every time. Sold in packs of 100 or new 1,000 packs.
|
Washer head seats screw, preventing a crushed pocket & run through. 
For hardwoods, choose the fine thread. For softwoods and particleboard, the coarse thread gives you the driving and holding you need, with a self-tapping wood auger tip. The square drive washer head properly seats the screw in the bottom of the pocket hole, preventing the head from crushing the pocket in softer woods and particle board. The auger points provide for easy installation and minimal splitting. The dri-lube finish reduces friction for easy installation and protects from rust. You just need a standard pocket hole step drill for both #7 and #8 screws. Optional
Bin Boxes are available with your order.
|
| |

Customer Reviews and Photos for: Kreg Washer Head Face Frame Screws
|
Average Rating:
(4.8)
(15 customer reviews)
Add your review...
|
|
|
1) Submitted by
Mark, from Asheville, NC
on 11/18/2009
Customer Rating: 
Great screws. The square drive gives you exact control over the amount of torque you want to apply in any situation.
|
|
2) Submitted by
Donn Pinckney, from Aberdeen, WA
on 9/1/2009
Customer Rating: 
I used these screws to fasten steam bent oak on a countertop edge. They really sucked it in tight. The head size is not given for #8 screws but a 3/8" counterbore was just right.
|
|
3) Submitted by
Dave, from Saint Joseph, MI
on 7/21/2009
Customer Rating: 
Good screws. Although they are sold as self-drilling, they still cause splitting in hickory. Pilot drilling for the screw tip was an additional step necessary.
|
|
4) Submitted by
Robert Hibberd, from Lutz, FL
on 4/24/2009
Customer Rating: 
In a nut shell, the screws are great.
|
|
5) Submitted by
Robert Taylor, from Dublin, TX
on 4/3/2009
Customer Rating: 
These screws work great with the Kreg System.
|
|
6) Submitted by
Richard H., from Seaside, CA
on 3/21/2009
Customer Rating: 
Just finishing up a bathroom cabinet built using the Kreg Pocket Hole System. I can't say enough about the system and the screws. A real time and money saver!
|
|
7) Submitted by
Murray Roland, from Youngstown , NY
on 9/11/2008
Customer Rating: 
The hardwood floor that was installed in our "New Construction" home was squeaking very loudly because the installer did not set the staples at the correct angle, reducing the holding power & allowing the floor to float up from the floor. The 1 1/4" Washer head screw was just the right length to install from below, through the 3/4" sub floor and into the 5/8" engineered hardwood laminate without coming through the hardwood top surface.
|
See all
15 reviews...
|
Home Power Tools and Shop Accessories More Power Tools and Accessories Pocket Hole Jigs Kreg Washer Head Face Frame Screws
|
|