Kreg Drawer Mounting Brackets

Make drawer box installation for face frame or frameless cabinets a snap!

Designed for use with full-extension slides.
Brackets feature long toes, support tabs and 1/2'' markings.

More...

Once full-extension slides are mounted into the cabinet, simply clamp a bracket under each slide, set the drawer box into the drawer opening so it balances on the brackets, and pull the slide to the front of the drawer box. Drive screws and you’re done!
Works with Kreg Universal Drawer Slide Mounting Jig (#38444).
Includes left and right brackets.
Bracket measures 10" long x 4" high x 1-1/2" wide.
Plastic.

Kreg Drawer Mounting Jig Instructions

Back to overview

Customer Reviews and Photos for:
Kreg Drawer Mounting Brackets

Average Rating:

3.8
(6 customer reviews)

$9.99

Add your review...

1) Submitted by Barry, from St. Paul, MN on 7/12/2012

Customer Rating:

I used these for installing full extension drawer slides with both face frame and frame less applications. This jig really makes the job a LOT easier. It would be a better product with good instructions but I found a YouTube video that showed me the way. If your an average woodworker and will be installing drawer slides from time to time, I'd recommend this.

Let me point out that, in addition to the brackets, you ALSO need Kreg's Magnetic Drawer Slide Mounting Tool AND two "C" clamps. If it's a project without a face frame then you also need a locking clamp like Vice Grip with a long reach, about 8". Without the clamp you have no way to hold the Magnetic Drawer Slide Mounting Tool to your case.

I wish Kreg would sell stuff as a set so you have everything all at once. Fortunately for me the Rockler sales rep told me what I needed and I saved a couple of trips.

2) Submitted by Robert Hansen, from Delmar, NY on 1/30/2011

Customer Rating:

These work fine as long as the vertical face is fully supported. On some of my framelessassembly, I had to "extend" the vertical face with a piece of thin plywood to get propoer support. It is a good product idea but Kreg needs to tweak the design for frameless cabinets.

3) Submitted by Joe Roth, from Wooster, OHIO on 11/1/2009

Customer Rating:

Makes a cumbersome task a bit easier. This did exactly what I needed it to. It held the drawer solid so I could attach hardware. If you are doing any nuber of drawers it is very useful. I've yet to find a Kreg product that didn't perform as promised.

4) Submitted by Scott, from Scottsboro, AL on 11/7/2007

Customer Rating:

I purchased these to be my third hand when installing some drawers in a dresser I was building. They work as described and were a great purchase.

5) Submitted by Justin, from Reno, NV on 4/19/2011

Customer Rating:

These were not useful at all. If they were molded square, they might work. I was unwilling to mount my drawers unlevel. I find it doesn't take long to just lay out the hole pattern, and mount the slide half to the drawer box.

6) Submitted by Dan, from Elizabeth City, NC on 5/23/2006

Althought this item states it can be used for frameless and face frame cabinets, it is best used with face frame cabinets. I found it very difficult and very time consuming to use with frameless cabinets.

Kreg Drawer Mounting Brackets

Customer Reviews and Photos for: Kreg Drawer Mounting Brackets

Customer Reviews and Photos for:
Kreg Drawer Mounting Brackets