Customer Reviews and Photos for:
Custom Door Edge Router Bit
|
Average Rating:
4.6
(11 customer reviews)
$59.99
Add your review...
|
|
|
1) Submitted by
Dave, from McHenry, IL
on 5/19/2011
Customer Rating: 
Bought this bit to put an edge on the doors and drawers I already built for a bathroom vanity. I first did some test cuts on scraps of birch and liked the edge profile. However since I had already built the doors and drawers to fit my opening I could not use bit since it decreased the size of the material. Since I did like the profile on my next project I will take into consideration this fact when making the doors and drawers.
|
|
2) Submitted by
Sam Baldwin, from Afton, VA
on 2/5/2010
Customer Rating: 
Very easy to set up, created a great finish, made my doors look professional and they matched factory doors.
|
|
3) Submitted by
Annie Buma, from Seiad Valley, CA
on 8/22/2009
Customer Rating:
This bit gave my cabinet doors the professionally finished look I was after. Nice clean cuts. Need to take off very small amounts at a time to avoud chipping hardwood. Was helped by review that warned about the bit making doors smaller.
|
|
4) Submitted by
Marc Hall, from Buffalo, NY
on 2/14/2009
Customer Rating:
Another fine quality product from Rockler. Bought it to make kitchen cabinets. Works as required. Very clean edge.
|
|
5) Submitted by
Russell Taylor, from Valencia , CA
on 10/29/2008
Customer Rating:
This bit does the job flawlessly.
|
|
6) Submitted by
Todd Morgridge, from Gaylord, MI
on 3/10/2008
Customer Rating:
Tough Bit! Cut Oak like butter, a Cabinet Makers dream! Very Pleased.
|
|
7) Submitted by
Tommy, from Pasadena , TX
on 5/2/2008
Customer Rating:
The edge I was looking for. Beautiful
|
|
8) Submitted by
Pete Newman, from Lilburn, GA
on 10/7/2008
Customer Rating: 
Nice design. Cuts well. I had a little trouble however because the bit will easily reduce the size of the door if you're not very careful.
|
|
9) Submitted by
B Yost from WV
on 2/25/2008
Customer Rating:
Good product. Works as good as a router bit can. Used it for picture frames and it looks great.
|
|
10) Submitted by
Jim Kovach, from Anderson, IN
on 5/30/2010
Customer Rating:
In addition to watching for making the door smaller, I ran into a problem with the 35mm, 1/2 inch deep concealed hinge pocket hole on the inside of my doors. When using 3/4 inch material for the stiles, I found the 1/2 inch deep pocket began to slice thru the door on the front side. I had to remake the edges on the stiles and not rout the profile as deep. The slicing occurred right at the curve in the profile.
|
|
11) Submitted by
Robert Goss, from Stafford, VA
on 11/27/2007
Customer Rating:
It arrived quickly as things always do from Rockler. It made precision cuts on my drawer fronts, and seems to be a bit that I've added to my collection that I'll be able to count on for a long time. I edged 8 rather large drawer fronts plus several pieces during setup and it shows no sign that I even used it. Thanks again Rockler.
|
Routers and Accessories 
(0 Items)
If
you are not 100% satisfied with these bits, send them back for
a refund.