fantastic value on high quality router bits. These bits are
competitively priced while offering high performance and long
performance features include:
and K20 grade carbide for clean cutting action.
sharpening with 600 - 800 grit diamond wheels.
balanced for smooth operation.
anti-stick coating to reduce pitch and resin buildup.
you are not 100% satisfied with these bits, send them back for
It's easy to prevent mishaps if you take a few simple precautions.
1) Rockler recommends using 1/2'' shank router bits whenever possible.
1/2'' shanks provide better stability with less vibration to produce a smoother
cut and longer cutter life. 2) Make multiple light passes rather than one heavy cut. 3) Install your router bit so that 90% of the shank is inside the
collet. Here's a rule of thumb: fully insert the bit, then pull it back
1/16 to 1/8 of an inch. 4) Use a router table whenever possible. 5) When using large diameter bits, reduce the RPM of your router.
Then test your set-up on scrap lumber. 6) Always follow your router manufacturer's recommendations.
1) Submitted by
Dave, from McHenry, IL
Bought this bit to put an edge on the doors and drawers I already built for a bathroom vanity. I first did some test cuts on scraps of birch and liked the edge profile. However since I had already built the doors and drawers to fit my opening I could not use bit since it decreased the size of the material. Since I did like the profile on my next project I will take into consideration this fact when making the doors and drawers.
2) Submitted by
Sam Baldwin, from Afton, VA
Very easy to set up, created a great finish, made my doors look professional and they matched factory doors.
3) Submitted by
Annie Buma, from Seiad Valley, CA
This bit gave my cabinet doors the professionally finished look I was after. Nice clean cuts. Need to take off very small amounts at a time to avoud chipping hardwood. Was helped by review that warned about the bit making doors smaller.
4) Submitted by
Marc Hall, from Buffalo, NY
Another fine quality product from Rockler. Bought it to make kitchen cabinets. Works as required. Very clean edge.
5) Submitted by
Russell Taylor, from Valencia , CA
This bit does the job flawlessly.
6) Submitted by
Todd Morgridge, from Gaylord, MI
Tough Bit! Cut Oak like butter, a Cabinet Makers dream! Very Pleased.
7) Submitted by
Tommy, from Pasadena , TX
The edge I was looking for. Beautiful