Incra® Miter Slider Bars

Eliminate difficult and time-consuming setup operations while maintaining accuracy and repeatability! Extruded aluminum miter bar has adjustable aluminum runner for perfect sliding action and can be locked in place for stationary table saw and router table jigs.

• Available in 24'' and 18'' lengths.
• Works with any standard 3/8'' x 3/4'' miter slot.

Make your own featherboards, small and large crosscut boxes, 45° miter jig and your own jig designs. Won't warp, swell or shrink (unlike wooden runners), so the jigs you build will fit perfectly time after time. Technical Details: Available in 24'' and 18'' lengths. Works with any standard 3/8'' x 3/4'' miter slot. With easy to adjust width. Universal threaded mounting holes. Comes with FREE illustrated plans for making a variety of table saw jigs.

Incra Build-It System Instructions Incra Miter Slider Manual

Customer Reviews and Photos for: Incra® Miter Slider Bars Average Rating: 3.8 (5 customer reviews) Add your review...

1) Submitted by Tim , from Mebane, NC on 2/25/2011 Customer Rating: Ordered the 24" rail to complement the "Build-it" sled. Was easy to install and fits in the miter slot of my 10" Rigid saw perfectly.

2) Submitted by Dennis Edwards, from Johnstown, PA on 7/4/2010 Customer Rating: I always used oak as the slider on my sleds for my table saw and in the winter I had to add veneer, because it was loose and remove in the summer because it was too tight. This product did away with all that. I bought the 24", but would have been happier with the 18". The 24" are too long for me, but work just fine. They are very well made like all Incra products.

3) Submitted by David, from Edmond, OK on 3/19/2009 Customer Rating: Nice product and well made. I really liked the included instruction detailing additional uses for these slider bars.

4) Submitted by Neal Aronson, from Santa Cruz, CA on 10/23/2008 Customer Rating: I was very surprised to find that the sliders were thicker than the depth of my miter slot. I have a Rockwell contractor saw which I assume is fairly standard. The instructions for attaching the rails to the sled base suggest placing dimes in the bottom of the miter slots. I had to actually make dadoes on the bottom of the sled so it would float above the saw table. Otherwise not a bad product. I like the adjustability.

5) Submitted by Ray, from Potosi, MO on 1/7/2008 Customer Rating: Be careful before ordering this product. The only thing you are purchasing is the actual rail, not the entire sled. My wife thought she was purchasing the entire sled for my for a gift.