7° Dovetail Jig Router Bit for Porter- Cable 4210 and 4212 Dovetail Jigs

Don't miss a beat in your dovetailing projects – keep plenty of these bits on hand and get more done! Carbide-tipped replacement router bit for Porter- Cable 4210 and 4212 dovetail jigs.

Item No. A B C 20918 17/32'' 3/4'' 1/2'' A fantastic value on high quality router bits. These bits are competitively priced while offering high performance and long life. If you are not 100% satisfied with these bits, send them back for a refund. These larger bits are designed to be used in a router table. Router Safety Tips: It's easy to prevent mishaps if you take a few simple precautions. 1) Rockler recommends using 1/2'' shank router bits whenever possible. 1/2'' shanks provide better stability with less vibration to produce a smoother cut and longer cutter life. 2) Make multiple light passes rather than one heavy cut. 3) Install your router bit so that 90% of the shank is inside the collet. Here's a rule of thumb: fully insert the bit, then pull it back 1/16 to 1/8 of an inch. 4) Use a router table whenever possible. 5) When using large diameter bits, reduce the RPM of your router. Then test your set-up on scrap lumber. 6) Always follow your router manufacturer's recommendations.

Customer Reviews and Photos for: 7° Dovetail Jig Router Bit for Porter- Cable 4210 and 4212 Dovetail Jigs Average Rating: 5.0 (3 customer reviews) $19.99 Add your review...

1) Submitted by Roger Ringnalda, from Clarion, IA on 9/20/2009 Customer Rating: It was much easier to set my PC dovetail jig for half-blind dovetails with the Rockler bit installed than it had been previously with the PC-supplied bit. I found that the Rockler Bit cut very clean even in Baltic birch plywood drawer sides.

2) Submitted by Ralph, from Wexford, PA on 2/24/2009 Customer Rating: The Rockler PC bit is vastly superior to the bit that Porter Cable supplies with their 4212 Dovetail Jig. Not only does the Rockler actually measure 17/32" in diameter (PC bit measured 16/32" which made setting the cutting depth a real chore) but the bit cuts quickly, easily and neatly. One of the best investments I've made recently! I'd encourage anyone that owns the 4212 jig to replace their PC bit with the Rockler bit.

3) Submitted by Jim, from Brooklyn, NY on 9/7/2008 Customer Rating: Wanted to try out this bit out vs P-C bit and Rockler wins hands down. Price is good. Cuts just like it should. Very pleased.