Edge Routing Dust Port

Eliminates dust while flush trimming and routing small decorative edges — among the most common routing jobs woodworkers encounter! Offers easy tool-free installation onto any router baseplate that accepts a standard Porter Cable template guide bushing. 2-1/2" O.D. dust port.

Installs easily onto any router baseplate that accepts a standard Porter Cable template guide bushing. Knurled nut offers tool-free installation. Thread pattern for knurled nut is the same as a Porter Cable guide bushing, meaning replacement nuts are easily available. Works with bits up to 1" in diameter. Works with stock up to 1-3/8" thick. Bearing must be at least 1/2" dia. Dust port measures 2-1/2" O.D., and 2-1/4" I.D. Threaded post measures 1-3/16" dia. x 3/8"H. Shoulder portion of stud measures 1-3/8" dia. x 0.074"H.

Customer Reviews and Photos for: Edge Routing Dust Port Average Rating: 3.4 (18 customer reviews) $15.99 Add your review...

1) Submitted by Rick DeFlavis, from Bel Air, MD on 4/1/2011 Customer Rating: Works great. I used it with a laminate trimming bit to cut hardboard and it captured all visible dust.

2) Submitted by K.W., from Kingsville, MO on 7/18/2010 Customer Rating: This thing does everything they say it does. It does an excellent job keeping the chips and dust from getting all over the place. The only thing is you do have to do some sanding to get it to fit on my dust hose. It took about 2 minutes to get it to fit.

3) Submitted by Carol, from Pahrump, NV on 11/11/2009 Customer Rating: Fits good. Fast to hook up, pick up the sawdust.

4) Submitted by Dustin, from Lino Lakes, MN on 3/24/2009 Customer Rating: Great product! Eliminates essentially 100% of dust/chips created during edge routing operations. My only gripe is that the dust port doesn't mate up to any of my vacuum hoses - should be easy to fix with some sanding, but wish it would have been "right" from the factory.

5) Submitted by Les Derusha, from Kentwood, MI on 10/3/2008 Customer Rating: I edge joint melamine panels with the router to get a chip free edge on both sides. The down side is the mess created. All I can say about the Dust Port is WOW!, this thing eliminates almost all the debris! One of my best investments!

6) Submitted by John J. Lasser, from Jacksonville , AL on 4/8/2008 Customer Rating: Great! I use this product to edge my lumber before planing the edge with the help of a straight ega. My shop is crouded and hasn't any room left for a jointer. It is faster than using the table saw and more accurate.

7) Submitted by Tim from AZ on 3/14/2008 Customer Rating: I really like this product. I've been using it quite a bit lately; as I don't have a long bed jointer, I typically straighten the edges of boards by laying a straight board (like a piece of plywood) on top of the board I want to joint. Then, I run a top bearing router bit in my router to straighten the rough cut board. This attachment has made that job significantly easier - I no longer am standing in a pile of sawdust and I have much better visibility into what's going on at the bit. I also really like the fact that I'm not breathing in the wood dust like I used to be. All in all, a very impressive and functional attachment.

See all 18 reviews...