45 Degree Miter Sled

Compact footprint makes it easy to store — simply hang it from a nail by your saw!

Through slots provide a stable clamping surface that prevents the stock from lifting off the table.

Overview
More Info
Reviews
Videos

Perfect miters - no adjustments! Simply cut one piece on the leading face, one on the trailing face, and voilà! Since both pieces reference off a perfect 90° angle, the miters will fit perfectly.

More...

Pre-installed adjustable nylon pins provide a no-slop fit to the miter track.
Through-slots in the base allow you to securely clamp moldings at table level.
Can be easily drilled to add extended fences and stops.
High-impact polycarbonate ensures durability and low-friction sliding.
Fits a standard 3/8" x 3/4" miter slot.
Measures 5-1/2" in width and 10-3/8" in length. Clamping faces are 7-1/2" long.

45 Degree Miter Sled Instructions

Back to overview

Customer Reviews and Photos for:
45 Degree Miter Sled

Average Rating:

3.7
(85 customer reviews)

$25.99

Add your review...

1) Submitted by Terry, from Oklahoma City, OK on 2/10/2012

Customer Rating:

Before I used my miter sled ..I masked off 3 1/2 " wide "Pads" on the miter rail on the back side ...not the screw side then applied JB Weld to each of those masked areas . After it set up hard I took a flat file and fitted it to my miter slot in my saw ... This works great ...Its very easy to get an exact tight fit and still smooth and easy to slide... and as it wears later I can still bring the screws out ever so slightly to make those adjustments.

2) Submitted by Andrew, from Santa Cruz, CA on 6/3/2011

Customer Rating:

I have a Delta Shopmaster and it fits fine but needs fine tuning with the screws. The screws loosen every few cuts so you need to keep those adjusted. Otherwise it works fine.

3) Submitted by Andy Booth, from Williston , VT on 5/31/2011

Customer Rating:

I found it easy to use and great when I need perfect 45's.
It saved my bacon on one recent project.
Problems
- The plastic set screws used to tighten up the slid in the slot allow you to make not quite 45's although the combined angle is still 90 degrees
- The set screws are soft and will wear.
- The plastic surface was slippery. Solved this by gluing sandpaper to the surface.

4) Submitted by Carl Clark, from Ravenna, OH on 12/31/2010

Customer Rating:

Very simple, safe, easy to use, accurate 45's. I had been using a home made sliding table for my 45's. This little jig does it easier and just as accurate.

5) Submitted by Kyle, from Danville, KY on 9/13/2010

Customer Rating:

I just got this and to test it I found a strip of plywood and cut 4 triangles, eyeballing every cut. and I came out with a perfect square. no gaps because of an angle being off, and no set up. I can't wait for the 30 and 60 degree Miter Sleds. now that I've used it, I can't think of a reason why you wouldn't own this thing.

6) Submitted by Sam Baldwin, from Afton, VA on 2/4/2010

Customer Rating:

A real time saver for small frames easy setup.

7) Submitted by Nathan, from Kalamazoo, MI on 1/2/2010

Customer Rating:

Fits perfectly with my Ridgid TS3650 table saw. This is a very easy to use tool that just saved the perfect miters I needed for the table I'm building.

See all 85 reviews...