Top quality bits that meet the high demands of Rockler Woodworking and Hardware.
ROUTER BIT DIMENSIONS
Two flutes, Ball bearing guide. Bearing 3/8"
Item No.
A
B
C
D
R
91705
1"
1/2"
1/4"
1-1/4"
1/8"
91716
1-1/2"
3/4"
1/4"
1-1/4"
1/4"
91727
1"
1/2"
1/2"
1-1/2"
1/8"
91738
1-1/2"
3/4"
1/2"
1-1/2"
1/4"
A fantastic value on high quality router bits. These bits are competitively priced while offering high performance and long life.
Quality performance features include:
K10 and K20 grade carbide for clean cutting action.
Final sharpening with 600 - 800 grit diamond wheels.
Precision balanced for smooth operation.
Baked-on anti-stick coating to reduce pitch and resin buildup.
Get a great deal on these superior bits!
Buy 3 or more and get 10% off, or buy 6 or more and get 15% off.
If you are not 100% satisfied with these bits, send them back for a refund.
These
larger bits are designed to be used in a router
table.
Router Bit Set-Up Jigs - Set your
router bit to the precise height every time! Simply bring the router bit up through
the table and align the jig with the cutting edge of the bit.
Router
Safety Tips:
It's easy to prevent mishaps if you take a few simple precautions.
1) Rockler recommends using 1/2'' shank router bits whenever possible.
1/2'' shanks provide better stability with less vibration to produce a smoother
cut and longer cutter life. 2) Make multiple light passes rather than one heavy cut. 3) Install your router bit so that 90% of the shank is inside the
collet. Here's a rule of thumb: fully insert the bit, then pull it back
1/16 to 1/8 of an inch. 4) Use a router table whenever possible. 5) When using large diameter bits, reduce the RPM of your router.
Then test your set-up on scrap lumber. 6) Always follow your router manufacturer's recommendations.
1) Submitted by
Bruce , from Watertown, NY
on 11/22/2008
Customer Rating:
Very satisfied with this bit, I use it in prodution work at home and have already router over 250 feet of edges. Clean cuts great definition.
2) Submitted by
Bill Wdowicki, from Ventura, CA
on 10/9/2007
Cuts soft pine and red oak equally well, smooth, perfect cuts despite my inexperience.
"I just do not know what to say about ROCKLERs above and far beyond customer service except for a simple thank you which doesnt begin to even start but thank you (everyone at ROCKLER) so much for all that you do. To potential customers, if you do not go to ROCKLER, you should have because you will not be getting the best in the business. Thanks again ROCKLER. Harry & Harry SLC, UT" -
Harry & Harry SLC, UT
- 08/14/2009 See more...
CART
Two flutes, Ball bearing guide. Bearing 3/8"
Get a great deal on these superior bits!
If you are not 100% satisfied with these bits, send them back for a refund. 
These
larger bits are designed to be used in a 
