Customer Reviews and Photos for:
Jorgensen 3700 Bar Clamps
|
Average Rating:
4.3
(17 customer reviews)
Add your review...
|
|
|
1) Submitted by
Dean porter, from Riverside, CA
on 12/27/2012
Customer Rating: 
I've had mine for 20+ years and after I dropped one off the roof holding up 2x6x10 facia the wood handle broke. Now I need another. Tons of uses, not just clamping. I don't get alot of help around the house and these fit the bill when no-one else is around.
|
|
2) Submitted by
Dan, from Washburn, MISSOURI
on 3/26/2011
Customer Rating: 
Purchased 8 of your EZ-Clutch Quick Release System for Jorgensen 3700 Bar Clamps. They fit the 24" bar clamps ok, but will not clear the side ridges of the 36" bar clamps
|
|
3) Submitted by
Mike, from Attleboro, MA
on 3/13/2011
Customer Rating:
Got 2 24" Jorgenson bar clamps from Rockler recently. One was defective a rarity and Rockler replaced it immediately, even before I sent back the bad one. I love these clamps.
Blank for this bowl was glued up using Jorgenson Clamp.
|
|
4) Submitted by
Charles, from Centennial, CO
on 9/5/2009
Customer Rating:
I have collected several Jorgensen clamps over the years and have lost many clamp pads. These slide right on and the clamp is back in action! Simple and necessary and they fit the bill perfectly!
|
|
5) Submitted by
Kelly Rosenbaum, from Abilene, TX
on 5/10/2009
Customer Rating:
Bought my first Jorgensen bar clamp in 1977 and have added many other Jorgensen clamps including c-clamps & pipe clamps. All my Jorgensen clamps have been excellent products and have seen numerous glue-ups. I will purchase more as need arises!!
|
|
6) Submitted by
Dale Maley, from Fairbury, IL
on 4/30/2009
Customer Rating:
I have used Jorgensen clamps for 30 years. They cost a little more, but the extra cost is worth the quality compared to cheaper alternatives. I recently built 16 wooden models illustrating basic mechanical principles, and needed a few more Jorgensens.
|
|
7) Submitted by
Jim, from Middleburg, FL
on 2/3/2009
Customer Rating:
I find these bar clamps a lot of places, however this is the only place where they also have the clamp pads. I'm retired, but do woodworking on the side, and these clamps and pads are indispensable for the variety of work I do.
|
|
8) Submitted by
Barbara Wentz , from Kirkland, WA
on 2/26/2010
Customer Rating:
I would love these pads if they didn't leave on oily mark on the wood which can only be removed by sanding. Cleaning the pads with solvent didn't help. The first pair were fine but the next 15 pairs left stains so are unusable. Does anyone know how to fix this?
|
|
9) Submitted by
John Gray, from Effingham, IL
on 6/8/2008
Customer Rating:
I purchased the Jorgensen Steel Bar Clamps and Bar Clamp Pads and they are one of my most used clamps. They're great, buy some!
|
|
10) Submitted by
Jim, from Dover, OK
on 5/1/2009
Customer Rating:
It has much in common with a shirt pocket!
|
|
11) Submitted by
Mike Seaman, from Kenai, AK
on 4/27/2008
Customer Rating:
I was very happy to find these. They do an excellent job of protecting the clamped surface. I bought enough for all my clamps so I don't have to remove and install.
|
|
12) Submitted by
Carter Sio, from Newtown, PA
on 11/7/2006
I'm thrilled to find the Jorgensen light duty clamps in your catalog. As a woodworking teacher for 23 years at George School I have encountered plenty of clamps, and used just about all there are out there. These clamps are especially great for medium sized projects, especially a box project all of my beginners do in the first term. All the joints are done by hand, and these clamps make the glue up really easy and can pull together joints of all sizes and shapes, the good, the bad and the ugly.
|
|
13) Submitted by
Michael, from oceanside, CA
on 7/26/2007
Customer Rating:
Have many of these clamps and I do not baby them & never had one break yet. Orange paint helps you find them when there are a lot of clutter. Made a wall rack to hold them when not in use.
|
|
14) Submitted by
R, from South Berwick, ME
on 12/16/2010
Customer Rating:
I have the same problem Barbara Wentz had. An oily foot print stain from the pads. I'm still trying to remove these stains on my fresh red oak. Need some advice.
|
|
15) Submitted by
Mariah, from Dallas, TX
on 11/27/2011
Customer Rating:
I've never had any issues with Jorgensen clamps. As for the pads leaving oily stains. I haven't experienced this with Jorgensen but I've got another brand that do the same thing. From my research online it's an issue with the manufacturing process with the pads. The only way I've found to avoid the issue is to stick a call or extra strip of wood between the project and clamp to avoid the stain directly on my project.
|
|
16) Submitted by
Photoman, from Holt, MI
on 5/7/2012
Customer Rating:
Good for the short time, but the bar will bend when you put a lot of pressure on them, like doing a butcher block and one of your pieces has a little bow in it, I bent 3 out of 9 camps on this project.
|
|
17) Submitted by
John Gray, from Effingham, IL
on 3/7/2008
Customer Rating:
These are great clamps I have some that are similar made with the Rockler name on them and I do not like them. Jorgensen's are super and I use them all the time
|
Hand Tools and Shop Accessories 
(0 Items)
