Top quality straight router bits that meet the high standards of Rockler Woodworking and Hardware. One of the most common router bits, straight router bits are used to cut grooves, dadoes, rabbets, and for general purpose material removal.
Rockler Router Bits are the finest available for use in creating
jewelry boxes, humidors, and other small boxes and crafts!
Top quality bits that meet the high demands of Rockler Woodworking and Hardware.
A fantastic value on high quality router bits. These bits are competitively
priced while offering high performance and long life.
Quality performance features include:
K10 and K20 grade carbide for clean cutting action.
final sharpening with 600 - 800 grit diamond wheels.
Precision balanced for smooth operation.
If
you are not 100% satisfied with these bits, send them back for a refund.
Router
Safety Tips:
It's easy to prevent mishaps if you take a few simple precautions.
1) Rockler recommends using 1/2'' shank router bits whenever possible.
1/2'' shanks provide better stability with less vibration to produce a smoother
cut and longer cutter life. 2) Make multiple light passes rather than one heavy cut. 3) Install your router bit so that 90% of the shank is inside the
collet. Here's a rule of thumb: fully insert the bit, then pull it back
1/16 to 1/8 of an inch. 4) Use a router table whenever possible. 5) When using large diameter bits, reduce the RPM of your router.
Then test your set-up on scrap lumber. 6) Always follow your router manufacturer's recommendations.
1) Submitted by
Larry Van Dorn, from Noble, OK
on 1/11/2011
Customer Rating:
With the addition of the router featherboard kit I purchased, I was able to setup my table router to safely "plane" some 1/8" thick strips of red oak I cut using my thin rip table saw jig. The extra length the Straight Router Bit gave me was just the extra I needed. Thanks Rockler!
2) Submitted by
Joel , from Charlottesville, VA
on 11/14/2010
Customer Rating:
Great product - For me the longer bit was what I needed.
3) Submitted by
Jack Miller, from Savanna, IL
on 10/27/2009
Customer Rating:
The price was excellent and the bits are of high quality.
4) Submitted by
Ed, from Green Valley, AZ
on 9/8/2009
Customer Rating:
Fine bit. Worked as expected. A bit long however in my PC 690 router. With the standard PC base, I barely had enough router motor housing inside the base to hold it steady.
5) Submitted by
Frank Larson, from Medford, WI
on 7/2/2009
Customer Rating:
Nice clean dadoes in hardwood. The bit could be longer. I'm using it in a Dewalt plunge router mounted in a table. Not much of the shank is inside the collet to get the depth of cut I need.
6) Submitted by
Jake Neuffer, from New Harmony, IN
on 12/29/2008
Customer Rating:
As usual only the best quality products that I have found. Repeat customer and will be as long as I dabble in woodworking.
Customer Rating:
Purchased the 5/8" bit for a specialty inlay flooring job. Outperformed 2 other previosuly used bits by a long shot. Best quality bit I have used in 15 years. I will never go back to another- cut my use time in half.
"I have been ordering from Rockler for almost 20 years and have found their products to be very inexpensive and of high quality. Shipping is fast even when an item is back ordered. The best prices I have found anywhere." -
Orval
- 08/07/2012 See more...
Routers and Accessories 
(11 customer reviews)
(0 Items)
If
you are not 100% satisfied with these bits, send them back for a refund.
