Overview
Finally, a simple replacement for the tedious double-nut fitting on most hold-down toggle clamps! Change depth-of-pressure in seconds with the adjustable rubber foot, and for movement in-and-out along the arm just loosen a single set screw and adjust away. A comfortable locking knob caps it all off.Available in two sizes, 5/16" and 1/4", based on bolt-diameter. 5/16" adapter's inside dimension: 5/8" x 11/16". Inside dimension of 1/4 adapter: 9/16" x 9/16". Featured on all of our new toggle clamps! Patented.
Tech Spec
Reviews
If you have the old style...
Posted December 14, 2008
If you have the old style clamps (the ones with a "Good Hand" logo stamped on one side, and their model number on the other), the 28153 will work great with a little effort on your part. You'll have to grind the logo and model number sides of the clamp down a bit. But after that, you are good to go. The fine folks at Rockler helped me out with this, so kudos to them! If you have some of those old "Good Hand" clamps and a grinding wheel, this adaptation will make you life a little easier (and us old folks like that idea).
I can now use my toggle...
Posted November 27, 2008
I can now use my toggle clamps! The old system was so ackward to use that my clamps sat in a drawer, unused. Now, with the Rockler Quickset Adapter, I am using my toggle clamps daily.
This is far superior to the...
Posted October 20, 2008
This is far superior to the original design. It is much easier to adjust and achieve the setting you desire.
Videos
You may also like
Swipe to see more
