$599.99 (Average rating from all reviews) Review 1 of 4:
Love the table but there is not any hardware available to fit the slots for a fence. The bottom of the table has a 1/2 inch cut for the bolt head but when you use that type of head to fit in the slot the shaft is bigger than the slot it needs to go through to hold down your fence. Each time I tighten my fence I have to hold the bottom part of the screw that is on the under side of the table with a wrench to keep it from slipping.
From $6.49 (Average rating from all reviews) Review 1 of 83:
I bought this light to use on my scrollsaw, I have the exact scrollsaw shown in the product photos shown. However it would have been nice if the light would have worked like the photos. The flexible conduit is just a little short, and does not stay in place very well due to the covering, it could have been made out of a different material or maybe the conduit could be black "annodized". That would eliminate the brutal stiffness and wandering of the magnifying light head.
$16.79 (Average rating from all reviews) Review 1 of 14:
I have used this product for over a month and have had absolutely NO problems. I disagree with the comments about the knobs being poorly built. It is NOT necessary to tighten the knobs super tight which is probably why the knobs have not held up. I love this item and use it daily and would recommend it to anyone!
$64.99 (Average rating from all reviews) Review 1 of 5: I found that the flat head screws mounting the router stuck up from the surface of the plate. The countersinks are not deep enough, or the screws provided have heads which are too thick. I could have enlarged the countersinks, but it would have taken off the coating. Instead I ground the screws down so that they were flush with the plate. This only took a few minutes and was not a major problem. There were no instructions for the hardware. I was puzzled by how deep the large countersinks were for the 1/4" flatheads. They are sized for a 5/16" flat head at least. The screws provided were 1/4" x 20 which matched the inserts included. They did a very good job on milling the plate. It was very parallel and flat. The finish was flawless and it was well packed for shipping. It was...
$349.99 (Average rating from all reviews) Review 1 of 14:
There are two areas where I would rate this product as poor: 1 The table is not flat. It has a slight dip towards the middle of the table by about 1/32 inch. 2 The MDF fence boards are terrible. MDF is like paper, and they have a lot of friction to them. That's not good since your running your stock along the length of them. Mine were not even flat. I had to sand them to make them work. I will be making my own fence boards out of hard maple. Otherwise it is a functional router table, turning your router into an inexpensive shaper!
"I purchased 4 sets of Steel Table Legs at a huge discount! More than 50% off compared to what I thought was already a good deal from another online store. Had to cancel that one and thankful I found this site. My hours of searching online paid off. " -
- 08/29/2012 See more...