This was a decent product with one exception - the closure feature was extremely hard to overcome both when closing and opening the slide. I built a desk for a client and tried these slides out. They were easy to install, but I did not care for the amount of force required to get the slide to close onto the plastic retentioner. Not a bad product, but be aware of this one potential issue.

Nice slide, good value for the money, the only draw back I can see are the cheap screwss provided with the slides.  Fortunately I had screws left over from other slides but  those screws are of better quality and design. Other than this short-coming these are nice slides.

Face Frame rear brackets for series 757 drawer slides are made from plastic or nylon. I used these brackets in my kitchen drawers. Out of six sets of these brackets, four split and came apart. I realize that slides are rated at 100 lbs. I weighed my drawers the most one weighed was 22 lbs and this drawer was 4in deep. My kitchen is about 6 months old. I now have to redesign the back of my drawers.

1. This unit is heavy. I was able to assemble it completely on my own but a second hand would have been nice. I have a custom made bench for it as you can see in the pictures. The bed weighs over 60 lbs itself and was quite the challenge to get it up the without using the table itself as a lifting point, but as you can see it can be done. The gantry weighs about 35 lbs but it very awkward to move easily. I was worried about damaging it and the mounts so my solution was to lay down a thick piece of cardboard on the table. I then took a small aluminum 2 ton car jack and placed it on the bed. I moved the gantry motor carriage to the middle to set the side to side balance evenly. I then raised the jack up to...

Read all reviews for CNC Shark HD 2.0 Routing System with FREE Porter Cable 2-1/4HP Router! ($199.99 Value!)