Overview
Get a custom fit for your router table plate with this easy-to-use template. With an 8-1/4" x 11-3/4" design, it is perfectly sized for Rockler router plates and Bench Dog router plates.
- Templates are made of 1/2" MDF material.
- Instructions are permanently affixed to the template.
- We suggest using our 1/2" Pattern Cutting Bit #33536 (sold separately, but other 1/2" pattern bits also work.
- For best results, mount the template to the desired location of the router plate installation using double-face tape (sold separately).
- Optional Router Plate Leveling and Locking Hardware Pack sold separately.
Tech Spec
| Brand | Rockler |
|---|---|
| Weight (lbs) | 2.2300 |
Technical Downloads:
Reviews
This template is too big. You...
Posted October 13, 2010
This template is too big. You can make your own like I did and it will fit. This is a waste of time, wood and money!
I read previous reviews about a...
Posted September 17, 2010
I read previous reviews about a "loose plate fit" but purchased both the template and Rockler suggested flush router bit anyway. After very carefully using the template with the bit on a scrap piece of plywood, I, too, found the resulting "cut out" to be about 1/16th too big. I'll try other bits with collars,etc to try and tighten up the fit. I do have several other Rockler jigs that I'm very happy with and will continue to try new ones as they come out.
I also found the template to...
Posted September 13, 2010
I also found the template to be 1/16th too big all around. I used double-sided tape and one layer of cut-to-fit poster board to compensate, but it's still a bit too loose for me. I tried two layers of poster board on two test pieces, but that was too snug. I'm seriously thinking of using some sort of filler to close the remaining tiny gap.
Like others, I also purchased Rockler...
Posted September 4, 2009
Like others, I also purchased Rockler hardware in order to build my own router table. With material I have on hand plus Rocklers hardware I can build a nice router table at half the cost, or more, of a factory built table.
In building my own router table...
Posted August 2, 2009
In building my own router table I was concerned on the cut out for the router plate. I ordered a Rockler plate and the template and it worked great.
Videos
Related Products
Swipe to see more
You may also like
Swipe to see more
