Posted December 7, 2013
I had one of these a year or so ago and found the holes to be just a little undersized as others have said. I decided to try them again recently when they were on sale at my local store, thinking that even if the holes were undersized I could enlarge them a little. Turns out, the fit was pretty good! They hold the bits firmly, but I have no trouble getting them out. I cut these to size and installed them in some drawers I built for bit storage
The holes are way too tight....
Posted January 9, 2013
The holes are way too tight. I would have to wear thick leather gloves to get bits into and out of the tray without slicing open my fingers. I tried to drill the holes out larger with a 1/2" bit and that did not help much. I'll get a larger bit and try again. Product would be perfect for the drawers of the router table I'm just finishing if it had larger holes, but is not useful as delivered!
The holes are very tight. You...
Posted April 30, 2012
The holes are very tight. You have to push down fairly hard to insert the bit. Two hands are required to remove a bit, one to hold down the insert. All this force means that sometimes you come in contact with sharp bit edges. The insert cuts fairly easily for custom shapes and sizes.