Drill Press Tool Holder

  • Page:
    1. 1
  • Items 1 - 3 of 3
  • Page:
    1. 1
  • How-To Articles (3)
Product not found, but we found these articles.
  1. Turned Multi-bit Screwdrivers Project / Rockler How-to

    Turned Multi-bit Screwdrivers Project / Rockler How-to

    …your choice, a screwdriver bit holder, a rare-earth magnet, a screw and a photocopy of the full-size template. Figure 1: Use a Drill Press to drill out a hole in the center of the blank to fit the bit holder. First off, use a drill press to bore a hole for the bit holder on one end of your blank (in…

  2. How to Build a Mobile Tool Storage and Sharpening Cart / Rockler How-to

    How to Build a Mobile Tool Storage and Sharpening Cart / Rockler How-to

    …...) Making Tricky Tool Holders To drill the indent borings for the tool holders, the author suggests using a drill press, as a handheld drill would be more complicated and time consuming. Even though they are just a small part of this pretty substantial project, the tool holders (pieces 19 to 22)…

  3. How to Make a Cribbage Board Quickly and Easily from a Homemade Template / Rockler How-to

    How to Make a Cribbage Board Quickly and Easily from a Homemade Template / Rockler How-to

    …left by the first Forstner bit. Go ahead and drill the small hole for the magnet at this time, too. Using a drill press, drill out the corners of the card recess on the cribbage board's core piece, but don't start in on the peg holes. Next, drill out the four corners of the card recess as shown.…

  • Page:
    1. 1
  • Items 1 - 3 of 3
  • Page:
    1. 1
Feedback X