Offset Knife Hinge

  • Page:
    1. 1
  • Items 1 - 5 of 5
  • Page:
    1. 1
  • How-To Articles (5)
Related Categories: Inset Drawer Slides
Product not found, but we found these articles.
  1. Back to Basics: Offset Tracing / Rockler How-to

    Back to Basics: Offset Tracing / Rockler How-to

    …carefully with a utility knife and using the washer, trace the inside edge or negative of the cutout on your MDF template stock. * Torch02 February 20, 2010 at 10:31 am That is brilliant. I've had a couple of times where I've tried to figure out how to mark a consistent offset from a template.…

  2. Craftsman 21758 Portable Planer Features a Two Knife Cutterhead and a Unique Granite Slab Table / Rockler How-to

    Craftsman 21758 Portable Planer Features a Two Knife Cutterhead and a Unique Granite Slab Table / Rockler How-to

    …Further, the holes in the knives are slotted, so a knife can be shifted slightly to the side. This allows an old machinist's trick: If the knives get nicked (thus producing a slight raised ridge on the planed board), shifting the knives laterally offsets the nicks so you get a smooth cut again. The…

  3. Hand Saw Series - Veneer Saws / Rockler How-to

    Hand Saw Series - Veneer Saws / Rockler How-to

    …and used for exquisite details on a high end project. Only the proper hand saws will allow you that control. Thin veneers can be cut with a sharp knife, but knives tend to follow the grain and leave a rough edge. Sawing the veneers gives a square edge that allows for tighter joints in inlays or…

  4. Top Benchtop Electric Power Tools and Equipment for the Home Shop / Rockler How-to

    Top Benchtop Electric Power Tools and Equipment for the Home Shop / Rockler How-to

    …fence and slot-guided accessories (miter gauge, coping sled, etc.) allow a router to perform as a mini shaper or, fitted with a straight bit and offset fence faces, even as a jointer for straight-edging long boards. As a bonus, you can always remove a router from its table to use it freehand.(Hint:…

  5. This Cat Recipe Holder Wood Turning Project Makes a Perfect Holiday Gift / Rockler How-to

    This Cat Recipe Holder Wood Turning Project Makes a Perfect Holiday Gift / Rockler How-to

    …this project. Now it's time to make a paper template for the ears. Cats' ears are leaf-shaped and pointed. The point of the ear should be slightly offset from center. The "stem" should be about 3/8" wide so that the ears will be cupped when inserted into their mounting holes. Cut out the template…

  • Page:
    1. 1
  • Items 1 - 5 of 5
  • Page:
    1. 1
Feedback X