Rockler Ogee Reversible Rail & Stile Router Bit - 1-5/8" Dia x 15/16" H x 1/2" Shank
Mill cope and stick doors with a single cutter—just shift the profile cutter between the top and bottom of the stack. Unconditional guarantee.
Item #
23422
For those who make cabinet doors only occasionally, this cutter provides an affordable, space-saving solution to routing cope and stick joints. One bit cuts both rail and stile profiles; just remove the cutters and rearrange them to go from coping rail ends to routing grooves in the stiles. Because the bit is bearing-guided, you can also rout arched rails without a template or fence. Available in Chamfer, Ogee and Classical styles (27190, 23422 and 27602, respectively). 1-5/8" diameter x 15/16" cutter height x 1/2" shank. 5/8" bearing. Groove is 3/8"D x 1/4"H.
Instructions for Routing:
- To cut the groove and profile on the insides of the rails and stiles, run stock face down on table. Stack the bit (starting from the shank end) as follows: profile cutter, straight cutter, then bearing.
- To cope the ends of the rails, run stock face up on table. Stack the bit (starting from the shank end) as follows: straight cutter, bearing, then profile cutter.
- IMPORTANT SAFETY NOTE: Do not invert any of the cutters! Be sure the carbide is facing the right direction for the rotation of the router.
(1) Rockler Ogee Reversible Rail and Stile Bit
| Brand | Rockler |
|---|---|
| Weight | 0.350000 |
WARNING: Cancer & Reproductive Harm - www.P65Warnings.ca.govWARNING: Drilling, sawing, sanding or machining wood products can expose you to wood dust, a substance known to the State of California to cause cancer. Avoid inhaling wood dust or use a dust mask or other safeguards for personal protection. For more information go to www.P65Warnings.ca.gov/wood.
Related Products
