$7.99 Each
Direct Ship
Use this tap to cut threads on the track for our Rolling Barn Door kits (sold separately).

Tap for Rolling Barn Door Track

Item #
51422

This tap is used for cutting threads in the 6' track included with our Rolling Barn Door Hardware Kits (sold separately). Threads must be tapped in the ends of the track so that the end stops may be installed. The 6' tracks arrive untapped, so the ends must be tapped even if the track is intended to be used full-length. For your convenience, a hole is drilled through the entire length of the track, so no drill bit is required. Sold singly.

(1) Tap for Rolling Barn Door Track
More Information
Weight 0.0200
Tech Spec
  • For use with Rolling Barn Door Hardware Kits (#53578, sold separately)
  • 1/4-20 thread
  • Square shank for use with a hand-operated tap wrench or with a cordless drill
  • Straight flute with right-hand cut
  • Taper of 3-5 threads for easy, accurate thread starting
There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
Browse 1 question Browse 1 question and 1 answer
Why did you choose this?
Rockler Store
I used this item before for other customers with great satisfaction
Doug J on Nov 8, 2016
Recommended
David N on Aug 28, 2015
I used this item before for other customers with great satisfaction
Doug J on Nov 8, 2016
Required to install my Rockler Barn Door hardware, but not carried by the store!!! One day job now turns into a TWO WEEK DELAY!
Steve S on Sep 7, 2015
Recommended
David N on Aug 28, 2015
Required to install my Rockler Barn Door hardware, but not carried by the store!!! One day job now turns into a TWO WEEK DELAY!
Steve S on Sep 7, 2015
i bought this tap for hardware kit 53578 and my installer said it was not needed. end caps just pushed into place. who is right?
Richard S on Apr 27, 2015
BEST ANSWER: End caps also act as stops for.doors when they are screwed in they are.more secure
More Suggestions