These straight bits are slightly undersized to cut tight-fitting grooves and dadoes for plywood that is thinner than its stated nominal thickness, which applies to most plywood and veneered MDF. Typical straight bits leave an unsightly gap when used for plywood joinery. Use these bits to cut grooves, dadoes and rabbets. Of course, they can also be used for general purpose material removal or any application which requires a flat, finished bottom. The two-flute cutters give a smooth finish with a medium feed rate. Two flutes, 1/4" shank.
(1) Rockler Undersized Straight Router Bit, 1/4" Shank
Purchased the 31/64 bit for 1/2...Posted June 2, 2011
Purchased the 31/64 bit for 1/2 plywood. Used this bit to create dadoes in cherry for plywood inserts in the ends of a baby crib. Worked great and inserts fit perfectly!
Great product but I only wish...Posted December 22, 2010
Great product but I only wish that I had waited 3 weeks to order it so, I could have gotten free shipping!
I ordered all 3 of the...Posted September 2, 2010
I ordered all 3 of the undersized bits and have used them. They are great bits and ever joint was air tight.
Does a nice job.Posted April 3, 2010
Does a nice job.
Very high quality bit and they...Posted October 8, 2009
Very high quality bit and they shipped it quickly to me. It was hard to find this in a local store.