GRR-Ripper® Micro Jig Replacement 1/2'' Leg
Every once in a blue moon you miss the tunnel of your Grr-Ripper® push block and end up nicking the leg. Luckily, thanks to the push block, it's a lot cheaper to replace a plastic leg than a finger (and a lot less painful). All three Grr-Ripper replacement legs are available: the Center Leg, 1/4" Leg, and 1/2" Leg. All three are compatible with both the GR-100 (#62689, sold separately) and GR-200 (#30737, sold separately) Grr-Ripper models.
- 1/2" leg is ideal for ripping thin stock
- Center Leg is adjustable laterally to hold stock flat against the table
- Installation hardware not included. Please use hardware from your previous Grr-Ripper leg
- Keep the green Grr-Ripper pads clean with denatured alcohol or rubbing alcohol
|Manufacturer Part Number||GRP-4Y|