Cherry by the Piece-3/4" Thickness
Fully surfaced on all 4 sides to actual dimensions.
A long time favorite for its rich color and excellent workability, Cherry continues to gain popularity for use in fine furniture and cabinets. The wood leaves the sawmill with a pinkish, rosy tone, and continues to darken over years to a deep, lustrous red. The narrow sapwood has a creamy color, similar to Hard Maple. Cherry is easily worked with hand tools and takes an excellent finish and polish. All boards are machined S4S, and are planed to 1/8", 1/4", 1/2" and 3/4" thicknesses, relieving your planer of excess work. Thin boards are well-suited for edging, veneering, marquetry, sides for decorative boxes, bending stock and bent laminations, while the thicker boards are ideal for furniture, paneling, cabinet doors, mouldings, drawer sides, fine jewelry boxes and whatever else your imagination can dream up!
- Distribution: As many as five varieties of Black cherry are reported to thrive throughout North America
- Tree: Attains heights of about 100 feet (30 m) Average tree grows to about 80 feet (24 m) in height, and produces a tall trunk, about 24 inches (60 cm) in diameter. Cherry trees are usually large enough to harvest after 35 to 40 years. Full height is attained in about 100 years
- Light & Air-Induced Changes: Black cherry is very sensitive to UV light, which causes it to darken over time. UV light inhibitors in coatings can be used to prevent color change
- Grain: Fine grain. Material with dark wavy streaks are frequent. Quartersawn lumber has a shimmery appearance
- Texture: Fine and uniform. The wood often has narrow brown pith flecks and small gum pockets.
- Luster: Rich and satiny
- Odor: Emits a fruity aroma when cut
- Steam Bending: Good. Often compared to Beech and Ash
S4S - Surfaced Four Sides
- Planed on top and bottom surfaces to be parallel.
- Both edges are straight-line ripped perpendicular to top and bottom surfaces and parallel to each other.
- This milling produces boards that are ready for your craftsmanship. All surfaces are parallel and square allowing ends to be cut square or at any angle you require. Boards with this milling can also easily be ripped to whatever width your project requires.
- Great for all crafts, casework, furniture pieces, boxes, moldings...really any project!
(1) Cherry by the Piece-3/4" Thickness
- Drilling, sawing, sanding or machining wood products can expose you to wood dust, a substance known to the State of California to cause cancer. Avoid inhaling wood dust or use a dust mask or other safeguards for personal protection. For more information go to www.P65Warnings.ca.gov/wood.