Oneway Scroll Chuck System
2 levers plus 4 holes in body, 3 in the scroll gives you 1-handed tightening! ONEWAY chucks have been designed by a machinist with engineering input from material, heat treating, and plating specialists in order to satisfy the woodturner's every need. Chucks were designed to meet most turning needs. Less time spent getting ready to turn and more time spent turning means better quality, and more finished projects. Large projects can be turned more safely, and turning can be done at the ends of long stock. There are four lever holes in the body, and three holes in the scroll. This design creates a constant differential which allows one-handed tightening. Levers are made from high strength steel and will not deform or bend in use. This prevents damage to holes in the chuck.
Different jaw sets are available for the chuck, which allows you to fit the chuck to suit your specific needs. If your needs change or grow, these chucks can be adapted to change and grow as you do.
This chuck requires an insert, you can use:
|Manufacturer Part Number||2170|
If this is an older model, it might have a head spindle size of 3/4"-16TPI
1"-8TPI sku# 22726
Go down the right hand side of the page until you see a header labeled Technical Downloads.
Click on the Oneway and Talon chuck instructions and it will open a PDF for you that you can print