These straight bits are slightly undersized to cut tight-fitting grooves and dadoes for plywood that is thinner than its stated nominal thickness, which applies to most plywood and veneered MDF. Typical straight bits leave an unsightly gap when used for plywood joinery. Use these bits to cut grooves, dadoes and rabbets. Of course, they can also be used for general purpose material removal or any application which requires a flat, finished bottom. The two-flute cutters give a smooth finish with a medium feed rate. Two flutes, 1/2" shank.
(1) Rockler Undersized Straight Router Bit, 1/2" Shank
Cancer & Reproductive Harm - www.P65Warnings.ca.govWARNING:
Drilling, sawing, sanding or machining wood products can expose you to wood dust, a substance known to the State of California to cause cancer. Avoid inhaling wood dust or use a dust mask or other safeguards for personal protection. For more information go to www.P65Warnings.ca.gov/wood