Overview
Hold your turning blanks firmly to your faceplate without screw holes. Tape holds best to smooth, even and finished wood surfaces. With your blank held firmly, you can focus on turning your most beautiful pieces yet! Tape roll is 1" wide x 36 yards long.
Tech Spec
| Manufacturer Part Number | 505w |
|---|---|
| Weight (lbs) | 0.7600 |
| Type | Tape |
Reviews
Average Score:
2.7/5Super Sticky/Backing Hard to Remove? My Solution
Posted December 21, 2013
I don't do wood turning, but needed Really Sticky Tape, for me this is it. As others have stated the backing is hard to remove, following is what I suggest. The first time use a sharp knife to pick at the back and separate. Then before you cut off the piece you need, make sure to leave an overhang of the backing of at least 1/2"-1". Next time you use it you'll find it much easier to remove the backing since you now have a start tab hanging.
Pros: It is Super Sticky, which is what I need.
Cons: You lose a bit of tape each time you use the solution.
Pros: It is Super Sticky, which is what I need.
Cons: You lose a bit of tape each time you use the solution.
Strong Tack.
Posted November 6, 2013
The only tape I could find that holds wood down tight on my CNC machine. Agree the backing is hard to remove but I figured out a system. Attach tape to surface first. lightly score the top of the tape about a 1/2" length in the center of tape. Pick off with your fingernail. Comes off in 1 piece. If easier to remove backing I would have given it a 5.
I've used several brands of turners...
Posted October 3, 2013
I've used several brands of turners tape over the years and they've always worked well, but this stuff is absolutely terrible. It is nearly impossible to separate the plastic backing from the tape. I've tried to use this stuff several times and have had the same problem separating the backing each time. I've thrown it away because it is worthless.
I used this tape for both...
Posted September 20, 2013
I used this tape for both turning and holding router templates to work pieces. In both cases it worked very well. Held fast and was easy to remove with little to no adhesive residue left on the work piece. It is a bit harder to remove the backing then some others but not difficult. I used a sharp knife to peel the corner of the tape up and the rest peeled off easily by hand. Otherwise I would have given it five stars.
Unusable. Almost impossible to separate the...
Posted July 19, 2013
Unusable. Almost impossible to separate the backing paper. Bought two rolls, complete waste of money.
Videos
You may also like
Swipe to see more
