All categories
Page 6 - Wood
-
July 02, 2019While other methods work well, the author suggests using masking tape to "clamp" the edging during glue up, spacing the tape pieces around 2" apart. I asked some of my woodworker friends how they went about gluing solid wood edging to plywood, and I was surprised to learn that every one of them used a different technique, and very few were completely happy with their results.Read more -
June 21, 2019A cabinet with waterfall corner joints features continuous grain flow around the corners of the cabinet. A waterfall miter joint is a great way to highlight wood with beautiful grain. You'll learn how to cut the miters using a large crosscut sled and how to clamp this joint with temporary clamping cauls.Read more
-
Categories: Woodworking Joinery , Wood , Routers and CNCs , Cutting and Shaping Wood , Skill Builder VideosJune 21, 2019V-groove board is a decorative panel board similar to beadboard. It features chamfered edges that form a v-groove between each board. The v-groove creates a nice shadow line. You can purchase special router bit sets that will cut the tongue and groove joint and the v-groove in a single pass on each board, but you can also make these boards using more common router bits.Read more
-
Categories: Woodworking Joinery , Wood , Woodworking Projects , Cutting and Shaping Wood , Skill Builder VideosJune 19, 2019You can save money by making your own cabinet doors. Learn how to make frame and panel cabinet doors using a table saw and dado blade set. With this simple system, you can build custom cabinet doors for your home.Read more
-
June 18, 2019Installing drawer dividers is a great way to improve the storage organization in your kitchen, workshop, or bathroom cabinets. You can purchase divider inserts, but you'll be limited to their design. A better way is to make dividers that perfectly suit your storage needs. We show you three simple ways to make wood dividers for your drawers.Read more
-
June 12, 2019One of the best ways to fix dents in woodworking projects or furniture is to use heat and steam. Apply a few drops of water to the dent and then apply heat using a scrap of cloth and an iron.Read more
-
June 07, 2019Learn how to attach wood veneer to a plywood substrate. Veneer is a thin piece of solid wood. Plywood is most commonly used as the substrate because it is dimensionally stable, meaning that it does not expand and contract much with changes in temperature or humidity. Veneer is attached to the substrate with wood glue.Read more -
June 05, 2019Resawing lumber is cutting the stock lengthwise along the edge. Resawing a board creates a thinner piece of stock. This technique is used to make thin panels, such as veneer, and also to make book match panels. Learn how to choose the best band saw bladeRead more
-
May 24, 2019The dado joint is one of the strongest woodworking joints you can make. A dado joint is made from a three-sided channel cut across the grain of one work piece. A second, mating work piece fits into the slot. Dado joints are often used to build cabinets and bookshelves. Dado joints are easy to make using a table saw or router.Read more
-
May 21, 2019Water-based finishes can raise the grain fibers, leaving a rough surface. Before applying water-based finishes, it's a good idea to wet the surface with water to intentionally raise the grain. Then sand the surface with 400 grit sandpaper to smooth the surface. Now you can apply the finish and it will not raise the grain.Read more
-
April 30, 2019What are the best woods to use when building outdoor furniture? Learn which woods are best for outdoor projects. Ultraviolet rays and moisture are tough on wood. Not all wood can stand up to the elements. Learn which woods will last when exposed to prolonged outdoor conditions.Read more
